How to Repair a rusty Series 2 Land Rover - Welding and Grinding with Half Job George

In this video, I repair part of the Land Rover Series 2 Chassis I am restoring. I find a few holes I had forgotten about under a leg I welded on when I was doing the bulk of the chassis repairs. First I cut the affected area away with the angle grinder and a slitting disc, before cutting a new piece out and welding it in. Then I give it 4 coats of my favorite Dacrylite Paint!
---Contents----
00:00 Intro

[@deanecarson2837]

Enjoying the content George. Especially as I am restoring a S3 109 2.6l. I have a bare chassis and empty engine block so there is a lot to go.

[@HalfJobGeorge]

Thank you! Yes there is plenty to keep you going! I hope you enjoy the process as much as the end result though!?

[@jjf6893]

Not a singed beard in site. Top tip on the dtt 👍

[@HalfJobGeorge]

Not this time haha! Thanks 😊

[@ThePyklet]

If I'd welded like that I'd hide it too... I may have to offer welding lessons for plasma time.

[@HalfJobGeorge]

I know a bad worker always blames his tools but I prefer to think of it as justification for buying new ones ;)

[@Beardedexpat7614]

Careful George. That steel was hot.