DIY easy tutorial on replacing rotted T1-11 siding. Fast and easy! If I can do this, you can too!! 👍🏽 #howto #t1-11 #wood #diy #damage #siding
Пікірлер: 15
@Manny-mq8gm Жыл бұрын
I would have put a piece of Z flashing in there
@Butchandbellesvilla Жыл бұрын
You're 100%, especially with the raid and snow we get, however, we plan to replace the entire siding next season. Since we had left over from redoing a whole side, we just wanted to eliminate that ugly spot and eliminate penetration until then. Thanks and don't hesitate to advise 🙂@LM
@paulmonk78205 ай бұрын
To help keep the saw in a straight line, fasten a board below the cut for the saw to rest on as you make the cut. Another benefit is it holds the saw weight. 😊
@Butchandbellesvilla5 ай бұрын
@paulmonk7820 Thanks great tip! Definitely adding that to the bank of things we've learned doing this little project.
@ralphnolan3187 Жыл бұрын
Put 2x4 inside between studs too stabilize it
@Butchandbellesvilla Жыл бұрын
Didn't actually need it for this temporary patch but thanks for the tip!
@helenmendoza24372 жыл бұрын
My Brother is a complete Genius.
@Butchandbellesvilla2 жыл бұрын
You made his year!! 🥰 xoxo
@jeffpruden3234 Жыл бұрын
What about the joint where u cut ? Don't think moisture is gonna Penatrate that ?
@Butchandbellesvilla Жыл бұрын
Z-flashing would definitely have been the way to go for that seam, however this was a short term aesthetic repair. We figured since we had the extra t1-11 from replacing the entire side that we were cutting a window into we might as well patch this piece until we get to the bigger fix. Thanks for watching.
@belladreamshade57 Жыл бұрын
Super helpful; thank you!
@Butchandbellesvilla Жыл бұрын
We’re so glad you watched and found it useful! Xoxo Belle
@davefreeman149910 ай бұрын
If you prime and paint it it will last much longer.