How to replace a clutch in a 98 jeep wrangler tj

[@Snickezboy789]

This seems super intimidating

[@krisdesha8129]

Ya got excited when I saw it was only a 5 minute video, should have known better.

[@BB-hi5of]

Thanks for the video man! I just pulled mine out yesterday.. sadly my clutch was good however my throwout bearing was seized in place haha! I just greased up the bearing

[@GeorgeHamberhill]

Great video, short and to the point,🍻

[@ncl3306]

How similar would this be for the 2.4 L?

[@YourPledge]

Glad you were here!

[@cassiusclaynyc]

did you install the fork and throwout bearing together and then install on to the input shaft? How do the cotter pins, on the throwout fit onto the clutch fork? Did you pry them onto the fork and then install?

[@westinsgarage1569]

Wheat or white bread

[@scavenom2008]

Multi grain works best with no gluten of course 😄

[@mikep95133]

A great idea to tie up the front drive shaft out of the way instead of removing it completely. Saves time and effort.

[@edcuddy6087]

how does shifter remove

[@blackwatercanyon7315]

after you lift off the rubber boot like buddy show in the video you have to press down on the flat metal ring and turn it counter clockwise while its pressed,,,,mine was a pain but before i knew it I felt it turn a little and when I released it I grabbed the shifter and pulled it up and out she came! was a beauty of a feeling lol I reached from underneath the vehicle using both hands, youll find a way

[@greenbullitt6999]

wet toilet tissue and grease works ... eat the bread hahahaha

[@jonarterburn626]

You video is called how to replace your clutch plate and you showed nothing! LoL what a waste of time! "Here's how you do it, but..... I already did it and not showing how I did it" what a joke