Here on this vid we show you how to replace the diff centre gasket on a hilux.
Пікірлер: 41
@ReadTheShrill10 ай бұрын
Thanks for the help, I just replaced my gasket using this video. Tip: if you take the wheels off, it's actually really easy to line up the bolts on the backing plate, and you don't need a friend's help. As you slide the axle in, the splines on it will make contact with the diff about 3/8" before the bolts go into the ends of the diff housing. So after the axle splines mate with the diff, you can still spin the backing plate into position to mate up the bolts with their holes.
@TRAV3038710 ай бұрын
Awsome mate. See were all helping each other out good tip
@pilgrimhere6525 күн бұрын
Excellent demonstration,I needed to do that ,The mechanic charge 900 $ , I think I'll do it my self now 👍.
@TRAV303872 сағат бұрын
Its prety basic mate hope the vid helps
@dylanmartin919025 күн бұрын
I'm going to try and do this on my Hiace, I thought I had to take the propeller shaft out but this video shows that it's way easier than that. I reckon I've got no gear oil left inside mine. I watched a crazy russian guy run an old sedan dry with one wheel blocked and one off the ground and it took a beating before it welded itself together. Hopefully not too much damage inside. Thanks for the video
@danielmorris37688 ай бұрын
Mint video, everyone else’s videos make this look like a massive job, cheers for simplifying it
@TRAV303878 ай бұрын
Cheers mate its not a hard job i just wanted to make it simple.
@thomask.8533 Жыл бұрын
Trav, exactly what I needed! Thanks mate and greetings from Brisbane!
@TRAV30387 Жыл бұрын
No mate glad to help
@uterogers12 ай бұрын
Cheers for the video. I’ve got to do the same job on a Prado.
@SamuelLacey-ur9hu5 ай бұрын
Good video. Would be helpful for some people to show you putting the driveshaft back on to the diff.
@adhawk56329 ай бұрын
The tunes are cranking too👍👌🇦🇺
@ReinventingTheSteve Жыл бұрын
Cheers for this Trev, I've been thinkin of opening my diff to inspect and replace oil cos I went through a few water holes (no breathers)
@TRAV30387 Жыл бұрын
No worries you can drop the oil that should be enough flush it a fuew times
@ReinventingTheSteve Жыл бұрын
@@TRAV30387 yeah true, might just flush it out... reckon i could use diesel to flush? then fill with cheap oil, do a couple hundred Km's then empty and fill with good oil? also is your diff LSD from factory? mine is a 2002 kzn165r sr5, doesnt matter for flushing but just wondering and if yours is lsd what do you think of its locking ability? i have mechanical front lokka and am considering locking the rear aswell
@TRAV30387 Жыл бұрын
Hey yer mines an lsd id just fill it with oil and do repeat flushes till its clean have you had water go inside the diff?
@ReinventingTheSteve Жыл бұрын
@@TRAV30387 havent checked yet but i reckon, fresh/muddy deep puddles up to the sidesteps, maybe a touch over, no diff wine or issues but considering checking n flushing just to be safe
@TRAV30387 Жыл бұрын
Good idea remember oils cheep mechanical parts aren't
@TriNguyen-qq5ul Жыл бұрын
Great diy job mate
@b-ave_yourself Жыл бұрын
Cheers for the vid bro! 🤙 Just a quick question when dropping the tail shaft , can you you just bolt it up again ? Or does it have to line back up the way it come off.
@TRAV30387 Жыл бұрын
Eazy mate cheers just put it back up no lining requirements
@emiliomorales9700 Жыл бұрын
Nice Job my friend🤜🤛
@Nick4162211 ай бұрын
2:40. No your breather isn't blocked. It's a one-way valve. When you block the filler plug it creates a vacuum. So of course no air can enter the breather. Think about it.
@DarkmanGSX-S Жыл бұрын
On the 2016 hilux the breather is closed by a tiny spring and a rubber disc, so mostly closed.
@carlharries65467 ай бұрын
Good practice to change axle seals at the time to avoid leaks there mate.
@TRAV303877 ай бұрын
Definitely if i had them at the time i would have changed them
@RippSnortin Жыл бұрын
The breather closes under suction, and opens to relieve pressure.
@emiliomorales9700 Жыл бұрын
I have e question for 2009 Toyota tacoma 4x4 is the same?
@TRAV30387 Жыл бұрын
Id imagine it would b verry similar
@bm6645 Жыл бұрын
Hey mate, what year is your Hilux? Would this be the same process for a 2011 KUN26? Thanks mate!
@TRAV30387 Жыл бұрын
Its a 2000 model and yes basically the same principle
@lucianoribeiro24257 ай бұрын
Yes
@NtsuabXiong-x1w9 ай бұрын
What kind of the truck is that ❤
@TRAV303879 ай бұрын
Toyota hilux mate
@emiliomorales9700 Жыл бұрын
Du you remove yes one axel driver side my friend?
@TRAV30387 Жыл бұрын
Removed both
@pentergraph7 ай бұрын
Did this leak without the gasket goo? I did this shit 3 times and had clean as surfaces. Man i was annoyed
@TRAV303877 ай бұрын
It leaked with the gasket but its fine now. I bet it did