How to Replace Blower Motor Module 2008-2013 Nissan Rogue

Buy Now!
New Blower Motor Module from 1AAuto.com trq.video/ib-1...
This video shows you how to replace the Blower Motor Module in your 2008-2013 Nissan Rogue.
This repair was done on a 2009 Nissan Rogue S 2.5L Sport Utility 4-Door AWD Automatic and the process should be similar on the following vehicles:
2008 Nissan Rogue
2009 Nissan Rogue
2010 Nissan Rogue
2011 Nissan Rogue
2012 Nissan Rogue
2013 Nissan Rogue
Tools you will need:
• 10mm Socket trq.video/oa8r...
• 13mm Socket trq.video/obsd...
• Trim Tool Set trq.video/o9R-...
• Needle nose pliers trq.video/oCZ-...
• Needle nose pliers trq.video/oCZ-...
• Pliers
• T20 Socket
• Gloves trq.video/o3b-...
• Safety Glasses
Subscribe: / @trq
Check out our playlist:
Nissan Rogue 2008-13 1st Generation: • Nissan Rogue 2008-13 1...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@jtalb64]

Thanks guys! I wasn't sure if I didn't have air because of the blower motor or the resistor so I ended up replacing both. It turned out to be the resistor. Your videos made an intimidating task manageable, and saved me $600!!

[@كهرباءوميكانيكالسيارات]

I am from Iraq and I have benefited from this site a lot, thanks my friends.

[@billsaint9225]

Fantastic video, i replaced the resistor module and the blower motor.

[@70deeno]

Very good video from start to finish, others I have seen did not show the whole process... keep up the good work. Thank you.

[@Mmetz1281]

How long did this job take my daighters Rpgue needs one and I'm going to do it Friday, trying to figure out how much time I'll need to dedicate

[@uknowimright6269]

Does this correct the issue of blower more air in the floor than through the actual a/c vents?

[@Nathaniellgonzalez]

Does this modular location apply for the 2016 Nissan Rogue?

[@snaker513]

Thank you 🙏🏽

[@falcon3s872]

For resistor swap, I didn't have to take the pedal off, but it turned out it was the fan, so I had to do it anyway...