How to Replace Brake Master Cylinder 2005-2015 Toyota Tacoma

Buy Now!
New Brake Master Cylinder from 1AAuto.com 1aau.to/ia/ACBM...
This video shows you how to install a brake master cylinder on your 2005-2015 Toyota Tacoma. The brake master cylinder and fluid reservoir deliver the fluid and pressure needed to actuate your brake calipers or wheel cylinders. If your master cylinder is leaking or damaged, you need to replace it to ensure safe brake operation.
Estimated installation time for a professional technician is approximately: 1 hour 18 minutes
This repair was done on a 2010 Toyota Tacoma Base 2.7L Standard Cab Pickup 2-Door 4WD Manual and the process should be similar on the following vehicles:
2005 Toyota Tacoma
2006 Toyota Tacoma
2007 Toyota Tacoma
2008 Toyota Tacoma
2009 Toyota Tacoma
2010 Toyota Tacoma
2011 Toyota Tacoma
2012 Toyota Tacoma
2013 Toyota Tacoma
2014 Toyota Tacoma
2015 Toyota Tacoma
Tools you will need:
• Flat Blade Screwdriver 1aau.to/obMC/1A...
• 12mm Wrench 1aau.to/oaib/1A...
• 12mm Socket 1aau.to/ocig/1A...
• Hose Pliers
• Brake Fluid
• Cloth Rags 1aau.to/oSI/1AX...
• Fluid Transfer Pump
• Gloves 1aau.to/obox/1A...
• Rubber Vacuum Hose
• Safety Glasses
• Drain Pan
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@chiefpacman]

Great vid per usual. I'm curious as to what is the point of bleeding all four wheels. Can't you just bleed the farthest wheel and all the air in between would come out. Thanks