How to Replace Clutch Master Cylinder and Slave Cylinder? (COMPLETE Guide)

[@RcPikiDu]

Svaka cast 👍🏻 I dobra odluka zamijenit cijeli set, sad je to sve novo 😊

[@PLUKI4x4]

Tako je i sada sam miran da sve dela😊

[@leonardasmigmator784]

Great job 👌

[@PLUKI4x4]

Thank you!

[@sergiopaiva4926]

Good job! When you do transmission alignment?

[@PLUKI4x4]

Probably next year sorry.

[@sergiopaiva4926]

Ok continue the good job I bought a niva 1997 1.7i … after seeing you videos

[@PLUKI4x4]

@@sergiopaiva4926 That is so cool!! wish you a good luck

[@nulledmarian]

Good job. For newer Nivas (I think after 2012) the slave clutch cilinder it's self adjusting, therefore you're not having that nut for adjusting it. Not the best system, my clutch disk/pressure plate/flywheel were ok but because I couldn't adjust the slave cylinder it was a pain in the ass switching gears, therefore I "upgraded" to the old system.

[@PLUKI4x4]

Thank you so much for info! with old system I never had problems till now, but its really stright foward fix and should last for long time.

[@ZarkoVukcevic-d6n]

Svaka čast tebi jer se na ovom kanalu može dosta toga naučiti. I sam sređujem jednu Ladu Nivu i upravo mijenjam cilindar kvačila. Htio bih te pitati nešto u vezi pomoćnog cilindra.Da li onaj metal na koji se kače šarafi treba dobro nabiti u gumu da onaj zaobljeni dio legne ili samo malo ugurati pa ostaviti hidrauličnom pritisku da odradi svoj posao i da on na taj način uđe u gumu. Veliki pozdrav uz like i subscribe.

[@PLUKI4x4]

Slobodno ga nabijes ali ne treba siliti stavis sve na mjesto dobro odzračiš i peljaš😎 hvala ti na komentarima, zelim ti sreću sa ladom!