How To Replace Control Board // MINN KOTA POWERDRIVE

[@carlmankey9301]

Thank you for your video and your parts got my trolling motor running

[@MrRamhunter]

I have bought the bt upgrade on older model. was told the control board is bad. How can you confirm the board is bad.

[@RichardDanielson-i2q]

I have a 80 thrust min Kota it just started acting up it goes forward and reverse but as soon as you try to increase your power it stops forward and reverse do you have any idea what the problem my be. It is a 24volt motor the voltage gauge shows plenty of power.any suggestions would be helpful.thank you very much 👍😎

[@notsogood6249]

I learn so much from your video's. Have you ever done a video on where you should keep your trolling motor clean or lubricated? I have a 24V Fortex 80 lbs. on my bass boat and I just look for moving parts to keep clean and lubricated. I'm not sure if this is correct.

[@VizXRyRy]

The obvious question is, if I were to put this v2 board into my v1 Powerdrive, would that allow me to add the Copilot or iPilot accessories?

[@ChadCunningham-n7j]

Can you provide more details on what is needed to make a V1 unit operational after installing a V2 board? I didn’t know the foot pedal would need replaced? Mine has the copilot installed. What are the issues with the copilot and operating phobe? Your information is very helpful and is done well. Thanks

[@devonplant6742]

You will need the remote or the foot pedal for the v2. Your V1 pedal will be useless after the upgrade.

[@damonellison8112]

I have a v1 power drive with a serial number starting with mkaf. Can I replace the control board?

[@conniedarnell3517]

Do you have a phone #?