How To Replace Coolant Temperature Sensor on A 2006 Peugeot 206 SW

Hi, in this video, i will show How To Replace Coolant Temperature Sensor on A 2006 Peugeot 206 SW with a 1.4 petrol engine.
this job only needs a few tools i just used a 3/8 ratchet and a 19mm deep socket which i have already made a video on you can check it out in the link below
• What's in my Toolbox -...
do you have a 206 like this ? let me know in the comments
Dobby
#pug206
#carrepairs#peugeot #206 #gearlinkage #coolant #autorepair #pug

[@tiredhub3270]

thx for sharing, how to test the sensor!

[@dobbyrepairs]

No problem, and you can test the sensor with a multimeter and some hot water. It will have two pins in the connector Check the resistance of it out of the water it should have about 2000 ohms at room temperature depending on the temperature where u live , then put the metal part of the sensor in some hot water for a few minutes and test it again. If the value doesn't change , then you need a new one

[@tiredhub3270]

thx a lot!@@dobbyrepairs

[@satbilla9291]

Can you change it without draining?

[@dobbyrepairs]

You can change it without draining depending on how quickly you get the new one in some of the coolant will leak out

[@Ifixitagain]

are you sure it is not resistance you are checking on the sensor when you dip it in hot and cold water? there is no source for voltage if you remove it from the car)

[@dobbyrepairs]

Yes, sorry, I did mean resistance