How to Replace Engine Water Pump 09-18 Toyota RAV4

[@1AAuto]

√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto √ *Do it Yourself* √ *Save Money*

[@veeem3964]

Ok here I am again, it was the water pump bearing making the rattling & grinding sort of noise. I replaced the same and now the engine runs nice and smooth, without a whimper from the drive belt area, 👍 🙏 Well the job went off well with your guided video, but one thing I learnt is that you don’t have to really struggle taking that Alternator out as when you loosen the the top bolt about 1/16” out give it a slight tap on the head to move the nut about one mm away from the bracket the nut actually slides into the right housing of the nut in bracket and it’s got a V shape locking arrangement so it won’t rotate. Loosen the bottom bolt a bit and now remove the top bolt & bottom bolt & the Alternator would just slide out without a problem or having to lever it out. Even when putting the alternator back it’s very easy just slides into the bracket and when you tighten up the nut snugs it’s self up nice & firm and off course the bottom bolt comes off and goes back without any hassles once the top bolt is on. Well I ‘m happy it went off well. I got the water pump for about CA$74/- & coolant 50/50 for $25/- plus taxes. I wanted to share my finding about easy removal & fitting back of the Alternator for you guys who want to DIY Thanks A1 Guy once again & all the best

[@uclefriday2860]

I thought crisfix would show me how but a1 auto Really did empowered me to change my alternator on my camry Thanks you guys

[@veeem3964]

Very good and descriptive video showing a step by step procedure with the precautions to keep in mind . I have a rattling sound on my 2015 RAV 4 since of late could it be my water pump bearing. I put a large screw driver between the pulley and housing and wiggled it and the pulley actually shakes a bit, so it could be the bearings are worn out, shall appreciate a reply, why no RTV or grease on the gasket will it seal well dry Thanks for your time guy and all the best to you

[@Pitbullshorts23]

I just changed mine on my 2004 rav. I had way more space. You make it look so easy. Great video

[@1AAuto]

+Mountain Biker Thanks for the feedback and checking us out!

[@BabyGangsterIsMe]

how long is the water pump last on your rav4?

[@jeffmercer8389]

Skip all this bs, Support engine under with block of wood and floor jack, remove right side engine mount, remove tensioner, replace pump re install tensioner and mount done. 1hr if your a good mechanic 2 hrs maybe if you don't always work on cars. Torque bolts to specs very little 78 inch pounds about 8ftlbs, don't clean block with any chemical cleaner will damage gasket per manufacture

[@Happysmoker2008]

Great video showing a step by step procedure thanks

[@Gregs92584]

This tutorial worked great thanx for the excellent educational reference and saved me about 300 cause i threw in the tensioner for good measure

[@BabyGangsterIsMe]

how long is the water pump last?

[@espcustom]

Great vid, i guess that if it has not been done in a while, this is a good time to replace the thermostat while all these parts are removed.

[@joeygee11]

Great video. 2 comments. The thermostat is under the alternator. I always change it with a new water pump. Also, on the right (other side) of the motor is the coolant temp sensor. It’s a $14 ish part. I change that too.

[@smanand1234]

Very stepwise, extremely helpful, as in a textbook

[@1AAuto]

+smanand1234 Thank you! We love empowering our customers and showing how to perform DIY auto repairs with our high-quality auto parts. 1AAuto.com

[@An_Gold]

Great video, thanks

[@michaelneuner1826]

I had the same question also..... why no RTV on the Water Pump Gasket?

[@joseaguila1266]

Thanks for sharing! If a water pump gets stuck, it normally causes overheat to engine. Is it possible for the coolant to burst out or leak? Where will it leak or burst out? Thank you.

[@mustafaawadallah3496]

Have a question. Is there a trick to getting the alternator back on? I took mine off while replacing my water pump but for the life of me can’t get it aligned on the top bolt. I was able to get the top bolt aligned enough to get half way be can’t get it to align properly to thread to the other side . Do you have any suggestions? Any would be appreciated.

[@cordmiller679]

any tips on how you got it back on?

[@1AAuto]

+Cord Miller Great question! Check out our library for more videos here: 1aau.to/m/video-library-c

[@on1ytheb3st]

I'm guessing this is the 2AR-FE 2.5L 4 cylinder correct?

[@nataliaklimova2877]

Alternator 14mm socket bolts torque 38 ft lbs, belt tensioner 12mm socket bolt 15 ft lbs.

[@godovermoney1124]

I wonder why nobody uses Indian head gasket shellac anymore? That stuff was great!!!

[@luzsantiago5205]

Good job.

[@godovermoney1124]

10:36... i've seen nicer wheels on a 1980 moped 😮

[@herschelmayo2727]

Slotted brake rotors on backwards, as usual. The slots act like a water pump impeller to draw air and debris from the center and throw it out of the rotor. Nobody reads the stamps on them that says "passenger side" and "driver side."

[@Thatguy-tn5vj]

Why no rtv?

[@Bszp5413]

Is it just me, or is the rotor on backwards, it looks like it’s a driver side slotted and drilled rotor.

[@miguelleanos824]

I usually put silicone the gasket to make sure it seals.

[@Corkfish1]

Slotted disc brakes on an old Rav 4? Someone is putting a lot of money into an old car!

[@fw1421]

Corkfish1 Not really. I put a set on my 2011 RAV4 Limited V6 for $180.00 2 years ago. They work ok but tend to be noisier than un drilled and slotted brakes. If I had yo do it all over again I would skip the drilled and slotted rotors,too noisy.

[@thetechlibrarian]

You can get a full front kit from stop tech for $200.00 pads and rotors , I understand why. The stock pads could definitely use a little more bite it you do a lot of highway driving

[@Brian-vz5cu]

Did you notice that magical transformation between when he took the tire off and whe he started to remove the push pins??

[@jose-reyes]

@@Brian-vz5cu Seriously ... edited video

[@jeffjeffries3469]

Too bad this dude is so annoying.