How to Replace Ford Ranger Rear wheel bearing

Рет қаралды 9,540

Күн бұрын

Hello,
performing How to Replace Ford Ranger Rear wheel bearing.
This step-by-step guide will help you to carry out wheel bearing change on ford ranger & Mazda BT-50 2012 onwards.
This is just a guidance only. work on your own car always risky if you don't follow correct safety procedures or using of correct tools and correctly handling them.
Primetech automotive us, not getting any responsibilities of personal or property damages.
Always recommend using qualified mechanic to do this kind of repairs.
please subscribe to my channel. like and share videos.
comment your ideas.

Пікірлер: 15

@johndory649 5 ай бұрын

I need to do this job this week, best tutorial video I’ve seen on anything mechanical, simple, to the point no fluffy rubbish👍

@PrimeTechauto 5 ай бұрын

@@johndory649 thank you John. Good luck with the repair. ❤️❤️. Just a quick heads up. There are shims behind the hub. (In between diff housing and the hub) Don’t mixed up the shims with other side. Use them on the same side where it comes from. Cheers

@lucysoutdoors 6 ай бұрын

thanks for posting will be doing this job in a couple of weeks👍👍👍

@markprotheroe4057 3 ай бұрын

Mk2 you're meant to put completed shaft into axle but don't tighten axle bolts.Push shaft tight towards diff and then measure space between hub and axle.If its say 0.2mm then add a shim of about 1mm to take up space and not put too much pressure on bearing.Always add a bigger shim to space measured.That's from ford workshop manual. I did both sides a couple of years ago but they need doing again because i didn't measure space to add correct shims

@Grazni-Gari 2 ай бұрын

Кольцо легко снимается при откручивание гайка, только его нагреть надо и не обязательно до красна! Чтобы не сломать крышку подшипника, сделайте из куска трубы съёмник, с одной стороны болт, другую сторону трубы приварить аккуратно к внутренней обоймы подшипника!

@eugenejulyan2001 18 күн бұрын

Dear god… this is why I will never take my car to a mechanic… got the job done sure but just wow

@pilkipilki4472 3 ай бұрын

left rear has a left hand thread right rear right hand thread

@felipebrenner6870 3 ай бұрын

I did my bearing and now still a bit of playing on the bearing, I was just wondering if I have to adjust by removing one of the gaskets between the diff and the axle? Many thanks

@PrimeTechauto 3 ай бұрын

These gasket you mentioned... (they are shims) by removing or adding the shims will tight or loose the bearing. so yeah, if you have excessive play you might need to add more shims. by any chance did you mixed up the left & right shims.

@felipebrenner6870 3 ай бұрын

@@PrimeTechauto yea buddy I mixed them up and now I have to sort it out, thank you for your explanation it was exactly what I was thinking about the gaskets(shims)

@PrimeTechauto 3 ай бұрын

@@felipebrenner6870 that’s sounds good. Hope you sort this out with no hassle. Good luck mate…