How to Replace Lower Transmission Mount 00-04 Ford Focus

Buy Now!
New Engine & Transmission Mount Kit from 1AAuto.com 1aau.to/ib/1AEEK00554
1A Auto shows you how to remove, install, change or replace a broken, worn out transmission and motor mount. This video is applicable to the 00, 01, 02, 03, 04 Ford Focus
This process should be similar on the following vehicles:
2000 Ford Focus
2001 Ford Focus
2002 Ford Focus
2003 Ford Focus
2004 Ford Focus
2005 Ford Focus
2006 Ford Focus
2007 Ford Focus
🔧 List of tools used:
• 13mm Wrench 1aau.to/ohW/1AXAA00010
• 13mm Socket 1aau.to/oAD/1AXAA00015
• Ratchet 1aau.to/oC5/1AXAA00016
• Gloves 1aau.to/odB/1AXSS00048
Subscribe: / @1aauto
Check out our playlist:
Ford Auto Repair Videos: • Ford Auto Repair Videos
Ford Focus 2000-2004: • Ford Focus 1st Generat...
For More Info visit us at 1aau.to/h/bIm/
⚠ DISCLAIMER:
While 1A Auto strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. 1A Auto is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@1AAuto]

√ *Watch the Video* √ *Buy The Part at 1A Auto* 1aau.to/m/Visit-1AAuto √ *Do it Yourself* √ *Save Money*

[@ronniefrantzen2397]

This guy is my favorite

[@leonkennedy5135]

The bolt that goes up towards engine has snapped on mine whats best way to get it out and easy cheers

[@tomtarantelli1829]

Thank you for the great video! it helped me with the replacement on my 2001 Focus wagon 87000 miles DOHC. Odd that the bolts are different lengths and types. (Short one has a shoulder.) Mine were in opposite places. The shorter one with the shoulder was in the vertical position and heavily corroded due to contact with aluminum. After cleaning them well, I switched locations for them to match yours. Also, I tried to replace the part with the car on drive-on ramps. Didn't work well as not much front to back play. Ended up putting car on jack stands, much better! Thanks again!

[@1AAuto]

+Tom Tarantelli Thanks for checking us out!

[@flycorvus]

Easy peasy, when you do it.. Pain in the a$$, when I try.. :-)

[@joehyundaitech7961]

I have been working on the focus for 14 years now. years 2000 -05. that mount look good to me unless I did not see something that was broken. its called a torque strut. the trans mount is located under the battery tray . also you should be able to push the engine forward to avoid removing the bracket . I am used to the 03-05 2.0 doch and 2.3 doch thats how I do it on them. maybe this model is different. this model I have not done it on . change all 3 at the same time the pass front is the most common fail on these focuses . trans mount being next. torque struts not so common. if this mount was broken in any way IE torn rubber or so on it should have been shown in the video to the viewers not so easy to see on video.. torque spec 35 ft lbs

[@1AAuto]

Thank you for the feedback! +JOE FORD DIY

[@ajbrown2013]

Yep just jack the engine up a bit more and no need to remove that stubborn bracket also don't over tighten the bolts like I did today and brake the bolt off when you were already done and have to try and drill out that damn bolt now I'm looking for my welder so I can weld a bracket on lol

[@derekmitt23]

Do you know the thread size of the vertical bolt and horizontal bolt ?

[@alllifematters7080]

@@derekmitt23 probably too late but if you contacted a ford and spoke to their pars department they could help. I got a new bolt last year for £5

[@thomasfoster5200]

I just changed mine 4 hours ago and I didn't remove the bracket. I changed all 3 and it's a much smoother quiet ride.

[@gustavomijares5128]

Any video for a 99 ford contour SE V6 automatic. How to replace the transmission mount?

[@1AAuto]

+Gustavo Mijares Great question! Check out our library for more videos here: 1aau.to/m/video-library-c

[@DILLYBAR31869]

Do you guys have a video for a 2013 model?

[@1AAuto]

+Dillon Roundy We do not have a video for this repair right now, but we'll keep this request in mind for a future video! 1aau.to/m/Shop-1AAuto-c