How to Replace Master Cylinder 2003-2007 Honda Accord

Shop for New Auto Parts at 1AAuto.com trq.video/c-40-C
This video shows you how to install a new master brake cylinder in your 2003-2007 Honda Accord. The brake master cylinder and fluid reservoir deliver the fluid and pressure needed to actuate your brake calipers or wheel cylinders. If your master cylinder is leaking or damaged, you need to replace it to ensure safe brake operation.
Estimated installation time for a professional technician is approximately: 1 hour 36 minutes
This repair was done on a 2006 Honda Accord EX 3.0L Sedan 4-Door FWD Automatic and the process should be similar on the following vehicles:
2003 Honda Accord
2004 Honda Accord
2005 Honda Accord
2006 Honda Accord
2007 Honda Accord
Tools you will need:
• 10mm Wrench trq.video/oai8...
• 12mm Wrench trq.video/oai8...
• 10mm Socket trq.video/obR6...
• 12mm Socket trq.video/ocjG...
• 1/2 Inch Ratchet
• 1/4 Inch Ratchet trq.video/obR6...
• 3/8 Inch Drive Ratchet trq.video/ocjG...
• Torque Wrench trq.video/obna...
• Brake Fluid
• Brake Parts Cleaner
• Gloves trq.video/obqy...
• Safety Glasses
Subscribe: / @trq
Check out our playlist:
Honda Accord 2003-2007 7th Gen: • Honda Accord 2003-2007...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@brooklyn7941]

Do u need to bleed that new part or can u just put it on without doing that last part before install ?

[@justin2justin14]

Dose this also apply to a 2008 acura tsx? it should be the same exact engine and master cyl

[@pedrho121]

cool, when you do the brake bleeding where do you start in rhe front wheel or back wheels 🙏 please answer me

[@Grumpy262]

Start back passenger tire then driver back and so on

[@taranveersihra127]

So why did u not bleed furtherest away wheel? Started on the left front wheel where it's the closest. Is it opposite when u change the master cylinder vs just bleeding alone

[@williebeamer8786]

Where did you get that tool the auto ratchet

[@thatdude6503]

You started with the outside line..video invalid. 🤦🤦