How to Replace the Clutch Cable on an SV650

[@dawkinshero20]

I gotta figure out how to change my clutch but then I have to do that after. So thanks for this. Very well explained. 👍

[@ulteriormoto]

Glad I could help. Please subscribe if you haven’t already. 👍🏻

[@stuartleonard1775]

Good timing with this. I have just got one of these from Zoran. What product did you use to lubricate the cable? Do you have a quick turn throttle? This would be a good install to see👍🏻

[@ulteriormoto]

Perfect! I used the Motion Pro Cable Luber V3. Check out my other videos and you will see a review/how to for that on my other bike. It's exactly the same on the SV. Yes, I do have a quick turn throttle I picked up from Spears. That was a great mod and super easy. Slide the rubber cover off the throttle cable housing, unscrew the two screws holding the housing together. You'll see how the cables attach, similar to the clutch cable. Just remove them, slide the old tube off, and put the new one on. Reverse the process to reassemble and you're done. Might take 15 minutes max.

[@benjamindallman3495]

Awesome thanks for the help man! What clip ons are you running g for your handlebars? I have woodcraft and they run into the bolts on the triple tree.

[@ulteriormoto]

I have the 35mm Rise Side Mount Adjustable Angle Clip On Riser Kit. If your rise is sufficient it should clear the triple bolts. The other option is that you can get the ones angled toward the center of the forks. In my case I have both the rise and that center orientation. If you go with the center orientation, you probably want the short bars because you can’t slide them through the bar clamps like you can with the angled mounts.

[@benjamindallman3495]

@@ulteriormoto Thanks man!