How to replace the fuel filters on a 2013 Dodge Ram 6.7

[@azfishing2947]

Thank you!! I just paid over 400 bucks at the dealership for this to be done. I will be doing it myself for now on!

[@nabberify]

You just save me a lot of money. Just called the dealership and the cost for them to put on new fuel filters is $410 without tax. Thanks a lot for sharing your video.

[@jimthecarguy]

Wow $410 you did save a lot of cash great job.

[@thepunisher3597]

They are called stealerships for a reason

[@bb5094]

I appreciate it very much you taking your time and video taping this whole fuel filter change for us that like to work on our own vehicles. I am new to the diesel world but I like to learn and do it myself.

[@jimthecarguy]

+Jon D Good for you.That's how I got my start some 40 yrs ago.If you need any other advice let me know.

[@georgejohnson6789]

When you get to the "hold to confirm screen, you hit the scroll down button and 'OK' will appear. THEN, you hold the right arrow to confirm! Nice video btw.

[@Mbs1979]

Great video. I will be doing this on my 2013 Ram 2500 in about a month or so. I have watched this video about 5 times already to make sure I have it down.

[@jimthecarguy]

+mark shimala If you need any advice let me know also let me know how you do.

[@timcarps3664]

Thanks a lot for the video , first time changing the filters , everything went just as you described , my front filter took a 1 1/8 " though. Thanks again !

[@jimthecarguy]

+Tim Stephens Great job.I hope my video was helpful

[@1cleandude]

To reach my front fuel filter I use a 3/8 ratchet, two 8" extensions and a swivel. Works great and a lot easier on the back! Good vid thanks for the time and talent!!

[@allincamo]

Now doing one at a time makes GREAT sense. One thing I plan to do is get a glass jar and drain rear & front filters separate and let sit see if I see any water. Beings I get my diesel from only 2 sources. But man thanks for the advice. I will keep coming back for more helpful info.

[@jimthecarguy]

+Jim Cash. Thank you Jim.Changing the filters one at a time will save you a possible problem .

[@allincamo]

Yep...the air in the line issue. Would you say front first or rear. ?

[@jimthecarguy]

+Jim Cash. Most of the time i do the rear one first .As for the air in the lines.That happened once to me it was a real pain in the rear end .

[@knowmusicman157]

I carry a one gallon clean glass pickle jar with a lid. Any station I go to I shoot about a quart or less into the jar first. Check it and then use a funnel to put it in my tank if clean. Pump about 5 gallons in or 10, check it again.

[@willnicholas4474]

Plus one for including the reset at the end! Thanks for the info!

[@jimthecarguy]

I'm happy to help.Thank you for watching.

[@williamshardwoodspecialist6023]

Nice Video very well explained

[@GTOAviator]

Thanks for the video, but FFS don't ever just turn the engine over after a fuel filter change like that. Cycle on/off 4-5 times.

[@jimthecarguy]

+GTOAviator OK Thank you for your input

[@marcusjudd2925]

That made me cringe

[@btwbrand]

This truck and engine combination only runs the fuel pump when the engine is turning so cycling the key does nothing for priming the fuel. You are better off adding a small amount of clean diesel to the fuel bowl while the new filter is installed to help prime the system.

[@coconutinnv]

I’m late to the party, but thanks for the video - I just watched it. I do have a question, what kind of oil/lubricant do you use to lubricate the o-rings?

[@roberthancock7055]

I like the idea of running the engine between filter changes. Make a lot of sense. One question; why would the service information (CD) I have says to remove both negative battery cables before doing the fuel filter replacements?

[@jimthecarguy]

+Robert Hancock You know I'm not sure.This the first time I have heard that.

[@Raging2inches]

Thanks for the video.

[@jimthecarguy]

+Brian Parks Happy to help.

[@josereyna851]

very good video. thank for your time sir.

[@routerider9542]

good video and well explained thanks..

[@jimthecarguy]

I'm happy to help. Thank you for watching

[@geoffkail4572]

Jim does the 2011 3500 have a prefilter or just the one on the engine? and does the key of and on prime the 2011s. Good clear video thanks

[@harleyd500]

Would partially filling the filter canisters with clean fuel make sense to help the truck self prime?

[@frankdaniels4364]

Service manual says not to fill it that it will cause damage. It says to cycle the key 4 times. May have to bump the starter each time to let the pump run for 25 seconds each time.

[@leewalters3521]

Hey Jim, thanks for the video. I have the same model. However I could not open the front fuel filter cap until I had opened the yellow bleed vale. Do you know if this is common. No amount of effort would release the plastic nut until the yellow valve was untightened. This is slightly different than what's shown in the video. Thanks Lee

[@mikesevoian9807]

What do you use to lubricate the new o-rings?

[@jimthecarguy]

Mike Sevoian Good question Mike,I use some clean diesel fuel at my shop.

[@111roofer]

Great video. My truck has major idle roll/surging. I saw some people were saying it could be the fuel filters. Have you seen the fuel filters cause an idle surging? Thank You

[@walesbanks3204]

Do the rpm’s just up to about 900, to 1000

[@btwbrand]

This truck and engine combination only runs the fuel pump when the engine is turning so cycling the key does nothing for priming the fuel. You are better off adding a small amount of clean diesel to the fuel bowl while the new filter is installed to help prime the system.

[@budatrox9171]

Do you have to do front filter first?

[@Aventurero2004]

Every few miles you recomend to change the filters?

[@sherrikulas5913]

Are the part numbers for front and back the same? Was going to buy in bulk since it seems I'm changing it every 8K-10K miles. YIKES!

[@jimthecarguy]

Actually they are different numbers.

[@3rd_Millennium_Engineering]

Hey, thanks for the cool, video. Hey, whattaya from Brooklyn or what?!? C'mon get outta heah, :-). Really, thanks for taking the time. :-)

[@jimthecarguy]

+Ralph M Bohm Thank you for watching and your feedback.Wow how could you tell I'm from Brooklyn.Lol

[@rafafernandez1742]

Did you just lubricant the o-rings with the Diesel that came out of the filter your removed

[@jimthecarguy]

Thanks for watching.If you can use clean Diesel that would be better if not then yes you can use the oil from the old filter.

[@bigc6436]

Jim what number filter's fit the 6.7

[@anthonyarroyo2672]

Dose this go for a 2010 Dodge Ram 3500 diesel turbo dully

[@justinv1109]

I believe 2010-current ones all have two filters so it should go as well for dually s

[@itslexiandgrace2259]

awesome

[@mathewhoffer4541]

Loosen up a lil bit ??? you turned it like 15 fucking times ? also you said there is lil room for the socket ? I could use a 6 foot extension on it ?

[@leechenea8009]

Lol

[@douglasbehlattnet]

where can i get the special socket for dodge cummins 6.7 2014

[@jimthecarguy]

[e-mail] You should be able to order it from a auto parts store.If not than on line.

[@3rd_Millennium_Engineering]

doglas behl I found this site, if it helps: www.amazon.com/Lisle-14600-Fuel-Filter-Socket/dp/B000HI6KTA/ref=pd_bxgy_263_img_3?ie=UTF8&refRID=0E7DWT2B28KRS650JXT1

[@brandonwillis260]

1-1/8" will work also

[@ejayphila4541]

i cant find the rear filter on my 2012 look everywhere nothing does anyone have a picture under the truck could please help me

[@jimthecarguy]

Thanks for watching.

[@jondirive]

Ram 250?? lol 250 is for blue oval vehicles. You mean Ram 2500 sir. I know that you know that... :-)

[@jimthecarguy]

Dj Popo Oh Sh_t sorry.Thanks for pointing that out :)

[@jondirive]

Good video by the way...

[@jimthecarguy]

Thank you

[@knowmusicman157]

He made several mistakes on this one

[@mainstreetcamden]

It's not Dodge Ram anymore, it's just Ram Trucks. They separated in 2009. You should catch up!