How to replace the Rear Springs on the Mk2 Punto (classic) same process on fiat 500 and panda

[@ΒασίληςΜενιδιάτης-χ8γ]

Awesome job,great diy videos, well done !!!

[@PuntoHowto]

Thanks for your support !

[@raulparavisini1381]

Thank you!!!

[@TheAmrraouf]

First , im so happy you are back and posting great new videos Second , i want to know how to change tha fog light bulb in this car (fiat punto mk2 " classic" 2005 )

[@PuntoHowto]

Thanks for the support, if you check out the Video on this channel for replacing rear light bulbs this should answer your question. Video here-----> kzbin.info/www/bejne/aIGWmIJseZ6njZI

[@TheAmrraouf]

PuntoHowto thank you , but i watched this video before , this is not what i meant i want to change the "front" fog light bulb

[@TheAmrraouf]

PuntoHowto thank you , but i watched this video before , this is not what i meant i want to change the "front" fog light bulb

[@PuntoHowto]

ok, you need to get under the front bumper and remove the bulb from the back, sadly don't have a mk2 anymore so can't show you on video.

[@TheAmrraouf]

PuntoHowto ok thank u 🙌🏻

[@CheungCharlie]

I have Ford KA MK2 (Same as Fiat 500), you've shown a really quick short cut to replace springs when compared with other videos :)

[@PuntoHowto]

Thanks for the comment, this simple type of rear suspension is used on a lot of cars and is very easy to work on.

[@simplifygardening]

Great how to just what I need. I have a question the plug attaching to my heater blower resistor just under the dash has melted, Its the one that takes the four flat pins mine is a 2004 3 door 1.2 active. although i can find the resistor to buy i cannot find a plug. any ideas?

[@PuntoHowto]

It’s very hard to get this wiring, the best suggestion is try and get something from a scrapped car of which there are plenty about now, look you scrap yards in your area

[@cornishsean1]

really helpful video nicely done

[@PuntoHowto]

Thanks, thanks for watching thanks for letting me know it was helpful 👍

[@chatchatty2155]

is this the same for fiat grande punto great vid

[@PuntoHowto]

Similar but the rear suspension on the grande is very different by design

[@johnmara72]

Hi! I bought a set of used original springs for a MK2B Sporting 1.4 2004. (I hope so). Springs have markings on them: 2 yellow and 1 pink on the front and 2 yellow and 2 pink on the rear. Does anyone know if they are the correct springs ?

[@fizaraja2205]

Very good video 👌👍

[@PuntoHowto]

Thanks 😀

[@ipodgooroo]

Is this the same process as the same era Fiat Panda? (2004 1.1 active)

[@PuntoHowto]

Yes the suspension is a similar design so you shouldn’t find much different

[@simonhinson9367]

You say the rear suspension is different on a Fiat grande punto ?? Is it still a similar process a just as easy to change the rear springs on a Fiat grande punto 57 reg please?

[@PuntoHowto]

The process is likely very similar, I must admit I’ve not looked at it on the grande, I know the rear shock absorbers are completely different in the way the mount at the top but you may still be able to undo them the same way from the bottom

[@4kingHeidt]

Hi looks like the shock absorber bolts are new. if i need new bolts where do i buy them or what should i search for? dimensions?

[@PuntoHowto]

I always buy them from fiat, expensive for a couple of bolts but then you’ll always get the exact correct part for the job

[@JimmyThomasjtpro14]

Omg where did you get that die cast Punto from?!

[@PuntoHowto]

Mostly eBay

[@liefrido]

How much they cost ?

[@PuntoHowto]

It was a long time ago now but at that time they were about £15 each

[@user-mz3jx8xe7o]

Hi I need to do this on my car, Can you tell me where you put the jack I can't see on the video Thank you

[@PuntoHowto]

Where the rear suspension beam bolts to the car is about the strongest point to jack from at the back of the car

[@user-mz3jx8xe7o]

@@PuntoHowto Thank you I will give it a go

[@ballsack4321]

Thank you very much sir, I'm doing this job today, finished the front yesterday 😊