How to SAFELY Jack Up Your Foxbody Mustang

Bill shows you the proper way to lift your Foxbody Mustang and the correct jack placements.
Subscribe to CJ Pony Parts on KZbin here:
www.youtube.com...
To keep up with all Ford info, check out our Resource Center here:
www.cjponypart...
To read more about this, check out our Resource Center article here:
www.cjponypart...
Music Provided By:
www.epidemicsou...
#CJPonyParts

[@davidkucher5.0Coy]

I'm inlove with your Fox Body all over again Bill, ooooh! Great tips thank you. 😎👍

[@TheCarCrazyGuy]

A QuickJack is also nice alternative.

[@longdriver1759]

Great video. Can you please tell me what Jack you are using? I like the low profile Jack and high throw of the handle. Much appreciated.

[@cjponyparts]

I believe this one is a Lisle but I would check out the low profile Daytona at Harbor Freight. I use one at home and it works great. Cheap too.

[@mattw8809]

Of course showing where the k member jack point would help

[@mattcox3373]

Literally the middle of the k-member.

[@david37203]

Thank you! Also, that is a sweet Fox!

[@jucedcustoms2274]

Great video those subframe cars can be tricky.

[@mccranahan747]

I thought putting the stands that far out on the axles could bend the axle housing tubes? I’ve always put them closer to the 🎃 . Could be BS but better safe then sorry.

[@mysticker11]

if i ever get a flat ima figure out how to change it my self on side of road..if i call a tow company pretty sure ill have a chance getting a tow guy that tears my car apart loading and unloading..not taking chances...

[@24theMoney]

There is a difference between stock stamped steel K-member vs. welded tubular steel aftermarket K-member. Stock K-member will bend eventually jacking it up as shown.

[@1tokeover]

Then how do you jack it up

[@S.Matt240]

I don't have subframe connectors and I'm doing lowering springs so this doesn't help me at all

[@nothanks5652]

use the factory subframe then, or k member and lower torque boxes, plenty of lifting points on a fox body besides the flimsy pinch welds.....

[@S.Matt240]

@@nothanks5652 Thanks!! I appreciate it.

[@matthewknock4095]

Great series!! What color paint is that? Love it!

[@i-tiyahman6519]

I rather use the Ramps first now you have Hight then Jack the rear

[@1calvin]

Thanks for the video but you left out some other spots also (not necessary) how to make sure your jack stands are locked or removed properly you can use the jack as a secondary (not first) support

[@jayb1836]

Could you make a video and show us? We all out here looking for info if you have any to share it would be appreciated by the community as whole

[@beloved_sojourner]

Well done

[@donphillips599]

Did not help I want g to change driver tire floor jack won’t reach to fo front

[@ladies.love.lorenzo]

What kind of floor jack is that

[@morrisf3957]

I only feel safe on a hoist.