How to Set Battery Setting on Renogy Rover 60 Amp Controller

So on the ‪@RenogySolar‬ FB page "Renogy Power Users" a couple followers were asking how to custom set battery parameter using on the Rover series Charge controllers. This is a short video of how to go through and set battery parameters using the "User Mode" on the Renogy 60 amd Rover Controller.
Thanks for checking in and please like and subscribe.

[@sejac1232]

Thanks for the video, I am having a Battery over Voltage error on my Renogy that I am trying to discover why? I think it is because my solar panels are putting out more voltage than I am using, although I am not sure.

[@Tool_Shed_Talk]

I've been having some issues with that myself, and not sure why as my system is so Renogy put together to their specs. As I learn more I will post about it. Meanwhile, how is your system configured?

[@spanky9973]

I had the same problem with my new batteries. I just installed two new ADCBATT 12.8V 100AH batteries last weekend. I am using a Renogy Rover 40A MPPT charge controller. I went to the battery manufacturers website and found a new version of their manual. I set the equalize voltage to 14.0V. Boost and float voltages were set to 13.8V. This fixed the issue for my batteries. I would strongly recommend checking your battery manufacturers website for a manual. And use their recommended settings. Best of luck.

[@BigDrinkTEA]

Same problem here, but according to the Victron it's never overcharged. I just got the smart shunt, still keeping the Victron for the history. Now the whole system is Renogy which is 4 175 watt flexible solar panels, 4 170ah, 2k inverter, 50amp dc/dc 60 & 40 rover, smart shunt, 400 watt solar blanket, and 200 watt folding solar panel. Almost 5 years running with 254 charge cycles. The most I get with full charge is around 530ah. I beat these bad boys up with my steam shower. The steamer takes about 100 amps to run.