HOW TO SETUP LEMON RX GEN 2 7 CHANNEL STABILIZED RX by FGFRC

[@bobmabel8543]

Yet again, exactly the video I was looking for! My go-to RC expert - many thanks (once again) from the UK 🇬🇧

[@FatGuyFliesRC]

Glad it was helpful!

[@bobmabel8543]

@@FatGuyFliesRC Hi there. Quick question: I’ve set up this receiver - your instructions were very helpful. The thing I’m having trouble with is turning the gains up (or even finding them). I run a Spektrum NX6. I ‘think’ the control surfaces are reacting correctly but the movement is so small I’m not entirely sure. Many thanks and have a great weekend. Edit: Ha, you can tell I’m new to all this. I’ve just had a look at the manual you put a link to in the title. The gain pots are on the Rx and can be adjusted there? Am I right in thinking I can’t vary the gains from my Tx because I only have 6 channels? Happy flying!

[@CHILLON26]

Just wanna thank you for the constructive and informative video. It aided in the assembly of my Banshee and Futura 64mm jets. I’m using the NX-8 with the latest firmware and everything worked out great 👍.

[@FatGuyFliesRC]

Glad it helped! And thanks for stopping by!!

[@robc5296]

This was a much needed video- thanks so much for sharing! I plan on putting one of these in my Bixler 3- as the wind can go from dead calm to out of control during any given flight at my flying field.

[@FatGuyFliesRC]

Very glad to help!!

[@alexherrera3918]

very few videos on setting up this lemon rx, thanks for sharing!!!

[@FatGuyFliesRC]

You bet!

[@Bill14886]

I found setting up that Lemmon RX is quite easy. Took me a few times to re read and fully understand how to make changes but once done I'm very happy with it. Best part mounted like yours you can fine tune each one of the three gyro pots with a micro screw driver. I'm putting one in my Viper 70 and pulling out the Spektrum cause I can't figure out how to add gain channel on a nob like the Lemmon.

[@FatGuyFliesRC]

It is not hard as long as you follow the instructions. World better value than Spektrum.

[@kassimtufail9061]

Great video highly recommended 👍

[@FatGuyFliesRC]

Glad you think so!

[@tructran8783]

Wow... great. You are great. I will get some lemon RX/stabilizers for summer :-)

[@FatGuyFliesRC]

Just as good if not better range than Spectrum and 3rd the cost.

[@franks.jr.7236]

Thanks was wondering about these receiver's and how to set up

[@FatGuyFliesRC]

Glad I could help

[@786free1]

Great video, very thorough love it. Just wondering if these Lemon Rx require firmware update in the future how would it be done?

[@FatGuyFliesRC]

I do not believe so. It mat be done through he satellite port with an adaptor is my guess.

[@my66gt350]

Thanks what I needed to reverse the stablization channel!

[@FatGuyFliesRC]

Happy to help!

[@PeterQuinn-n5n]

Hi can you help I have setup the lemon recever all OK but the ruder and elevator mix together and I cannot stop them in the nx8 transmitter have you got any ideas please.

[@FatGuyFliesRC]

I would do a factory reset on the receiver and start over. Sounds like you have the wrong wingtype picked on the lemon.

[@PeterQuinn-n5n]

Thanks for the info Guy you are bang on with the wrong wing type it fixed it I am very happy so thanks a million and great videos as well .👍

[@rafaeltorres2886]

Thank you, buddy😊

[@FatGuyFliesRC]

You're welcome 😊

[@waynetri1]

Hello Sir! I have an iX14 Spekrum and Lemon 10Ch receiver for Conscendo Evo. Please tell me how to set up A switch for 0 Normal flight/1 for stabilizer and R knob for gain? Thank you!

[@FatGuyFliesRC]

As long as the stabilizer is enabled then you can assign it to a switch. it is AUX2 by default and channel 7 in your transmitter. Also by default channel 8 and aux 3 are assigned to adjust the gains.So all you have to do is decide in your transmitter you want channel 7 and 8 to go. I always use "c" with my lemon rx as the one that switches gyro on and off. And I use my "roller" for channel 8 to adjust gains up or down. Hope this helps. Here is the online manual I use when I get confused (it is for the 7 channel version but the same for the 10) cdn.shopify.com/s/files/1/1052/4162/files/7CH_Telemetry_Essential_Instructions_R1.0.pdf

[@waynetri1]

@@FatGuyFliesRC Thank you so much for your fast responded Sir! This information will help me out a lot!

[@1960Ewald]

hay fgfr,when you fly whit the lemon rx reciever whit the gyro on,do you have full control ore are the controls limited like the spektrum reciever?. Keep up the good work.Greetings from the Netherlands

[@FatGuyFliesRC]

yes full control just helps with wind, Thanks so much!! and here is that rx: www.motionrc.com/LAbBov

[@1960Ewald]

@@FatGuyFliesRC Thank you very much

[@Runk3lsmcdougal]

Great tutorial tyvm!

[@FatGuyFliesRC]

You are so welcome!

[@brandonwesson6818]

About to order a OMP hobby edge 540 60inch PNP model. Do you believe this would be a good Rx for it? Just wanting stabilizer just incase something was to ever happen and wind gyro would be nice. Thank you

[@FatGuyFliesRC]

Yes but go ahead and order the small satellite receiver , it will come with a wire already. There is a lot of carbon fiber in that Edge 540 . remember that stabilizer is for wind only, not self level.

[@brandonwesson6818]

​@FatGuyFliesRC ok thank you. I wonder how the FMS reflex V3 would work in it? I was really wanting self leveling just incase I ever got in a bind.

[@vicolrc62]

Thanks, FGFRC!!

[@FatGuyFliesRC]

Most welcome!!

[@henryhartsfield4574]

Want to put this receiver in my Xane Mig 17 wich (R) should i use? Thanks!!!!!

[@FatGuyFliesRC]

Well i use Spektrum iX 14 if that is what your asking.

[@stevejamelskyj5761]

Which ch did u assigne the undercarriage I have same but mines connected to gyro switch

[@FatGuyFliesRC]

gear channel

[@stevejamelskyj5761]

I have 2ngen in my f16 80mm but it's on ch gear so I can't use my gear how do u allocate ch for gear or move stabilisation ch

[@FatGuyFliesRC]

To control the stablization it is automatically assigned to aux 2 in your transmitter change aux 2 to what ever switch you want. I choose the roller so i can adjust the gains up or down depending on the wind that day . Hope this help. Also in the description of this video is a link to the lemon rx set up guide. Thats is what i use.

[@PeterQuinn-n5n]

Hi can you help please I have a lemon 7 channel rx do you think it will work on a helicopter.

[@FatGuyFliesRC]

I don't know why not.

[@RCFlyBy911]

This gen 2 have SAFE ? I’ve done gone crashed & destroyed much of my hanger ! No shame in my game ! I simply have nowhere’s to fly anymore and smashed my jets into light poles , power lines , trees ! Even had a giant hawk dive bomb my lil citation jet. I didn’t even realize there were a gen 2 until now 🤣 man it sucks not having a field to fly. Thanks for the tutorial here I’ve always had mostly LEMONS IN MY JETS ,, unless it was an BNF model ✌🏼

[@FatGuyFliesRC]

No the GEN 2 they did away with SAFE they only have A wind gyro like AS3X.

[@Ethelsbarrelracing]

I don't know how good these lemon RX receivers are but it appears to be very complicated so I prefer reflex I also like hobby eagle gyros there gyro set up is way more straight forward I don't like complicated and it seems everything spectrum receivers and radio related is complicated

[@tructran8783]

I think Lemon 7 can have satellite ... Right?.

[@FatGuyFliesRC]

Yes they can

[@joeggeist5594]

Would be a great video except for all the damm commercials

[@FatGuyFliesRC]

I have no control on the commercials, you used to be able to pick skippable or bottom banner ones but no more.