Lemon 10-Channel DSMX Compatible Receiver with Gyro Stabilization Setup | Motion RC Quick Tip

[@txkflier]

Correction direction. Wingtip up, aileron up. Wingtip down, aileron down. Tail up, elevator up. Tail down, elevator down.

[@Grossman2868]

when you are setting up the gyro (plugging the ESC in while holding the C button) they fail to mention that the only plug that can be plugged in is the throttle/power (channel one) if you have everything else plugged in, you'll only get flashing green lights. Wasted a lot of time figuring that one out.

[@bigeclipse718]

Whoever this guy is.....i like best for the videos. The new guys are ok but this guy is my favorite.

[@warbuzzard7167]

Gotta admit, I hate the new Lemon receivers - the interface is so unintuitive and so hard to remember that I can never quite get a handle on what I'm attempting to program. I wish they came with a Bluetooth interface so I could just select my modes on my phone. It's so cryptic and weird ("hold this button for 3 seconds after you plug it in and wait for these sequence of lights to come on") that I find it unpleasant enough to avoid programming the receiver.

[@kostaskostas7219]

Lemon DSMP Satellite Receiver with Diversity Antenna Hou to setup?

[@alexherrera3918]

Is the master gain, also available on the gen 1 lemon stabilizer? thanks

[@charlesrestivo870]

Do u fly this in any of your jets ? Does Boozer fly these? Just curious

[@AndysEastCoastAdventures]

Holding c button and adding power, waiting for red & green lights to flash and release c button to program and I get green lights flashing, not the red ones?

[@Grossman2868]

I had the same thing. They don't tell you that you can't have anything else plugged in except the throttle/power cable. If you have the ailerons, elevator, rudder etc plugged in, you get the green lights.

[@Don-xy8cy]

I have my P51 setup with this, and a Radiomaster 16TXS. I have the flaps plugged into ch 6. How can i turn off stabilization on this channel? At the moment when the flaps are down the stabilization moves the flaps as well (not great for landing)

[@williewideback]

Does it come already program for a normal ( conventional ) option C: or we must program it regardless of what type plane we may have?

[@MotionRC]

nothing about the gyro is programmed from the start. You have to select option C

[@jamesdalton7694]

Freewing f4 , Spektrum NX8, Lemon gen 2 10 ch . To use the reversing feature can we switch ch 8 on and off with master gain set at mid range and then use pots for fine tuning? Can we then reassign channel 7 to switch the reversing feature on and off?

[@TerrariumFirma]

Do you know if its possible to use a gyro with models that are unconventional shapes, like a flying wing? How would you set it up? I am building a flying wing glider, which has elevons and drag rudders on the wing tips and want to put a gyro in it.

[@stevejamelskyj5761]

I'm trying to put landing gear on but if I connect it to gear then when I put gyro off the landing gear started to work how do u connect ch 7 to operate landing gear

[@GIBlackmomba]

Please do a video that demonstrates the built-in barometer, altimeter, energy meter (Current, Voltage, mAh), internal temperature sensor for the Spektrum DX9 Black transmitter? Thanks in advance, excellent video! - Retired 101st ABN DIV veteran.

[@charlesrestivo870]

If u flip gyro direction do u have to reverese surfaces individually or can you just reverse throws at once

[@toad2039]

can this be set up to act like spectrum safe ???

[@weseehowcommiegoogleis3770]

NO! NO! No matter what they hide in the Descriptors.

[@toad2039]

@weseehowcommiegoogleis3770 can't tell if your being sarcastic

[@weseehowcommiegoogleis3770]

@@toad2039 Lemon RX's Lack the function. So NO to your question.

[@rotormasher]

Funny, just ordered one tye other day came today

[@charlesrestivo870]

Would u trust that in a edf ?

[@mpojr]

how reliable is it? are there any known issues?

[@MotionRC]

Lemon has been around for a long time. DSMX/DSM2 users have been using them for years. They are very reliable.

[@MrSpryrob]

Do these new lemon gen2 rx have self leveling built in also?

[@rafaeltorres2886]

No.

[@Grossman2868]

you can program it to self level if it loses the transmitter connection, other than that, no.

[@sambartelet3265]

Het would this receiver work with an reely ht-10 transmitter and if not wich would?

[@alexherrera3918]

Can i connect this gyro as SBUS to a Hobbyeagle a3 mini?

[@CybaGirl]

Will this work with a Flysky FS i6X and a FrSky Taranis X9d Plus? Thanks

[@MotionRC]

These are Spektrum combatible

[@FlyMIfYouGotM]

It says this Rx will bind with any DSM2 and DSMX Tx but so far I have not been able to get it to bind with a TBS MPM Multi Mode Module, (STM32). I have a FrSky X10S Express Tx running the latest rev of Edge Tx and the TBS MPM module is flashed with the latest firmware rev. I am able to bind a Lemon 7 channel LM0081 and that works. I can bind this 10 channel LM0097 Rx if I use a Lemon LMT001 Tx module so I know the receiver and my Tx will function with a Lemon Tx module. The fact that the TBS MPM Tx module will bind with a Lemon LM0081 7 channel Rx tells me the TBS MPM Tx module is also working. Any idea what's going on?????

[@weseehowcommiegoogleis3770]

Lemon GYRO Stabilization is NOT Stabilized auto level flight. They sold themselves to SpeKtrum and removed that from their wares.

[@Backupaccidk]

Could I use this for the al37?

[@redwineisfine]

Always wondered why a manufacturer would choose "Lemon" for a name.. and then have a customer base that discusses quality.. But thats me..

[@ModitRC]

Lemon was created to combat the high pricing of Spectrum. It's a joke name.

[@nirlachman007]

Hey, in the Lemon Rx Gen2, how can I disable the gyro without using a dedicated switch and while my channel 7/5 are still free?

[@Grossman2868]

set the Aux 3 to your roller knob and set the travel for it to - 100% On my Spectrum 8 there are two numbers side by side, roll the roller knob all the way down and change the number on the left to 100%. When you roll the knob all the way counter clockwise, the gyro is off.

[@Bill14886]

How to you correct directions

[@stevejamelskyj5761]

I've done exactly like u have but can't even get gyro on or off any ideas it's new and everything else works

[@jaysrc]

Maaannn…I can’t get mine to work either…think I got a “lemon” ..pun intended…

[@k.g.1039]

Take it this receiver isn't compatible with Futaba transmitters?

[@MotionRC]

It is not no. This is for DSMX protocol

[@FlyMIfYouGotM]

If your Futaba Tx uses a plug-in JR style RF module, you should be able to use Lemon Rx's by plugging in an LMT001 Tx Module into your Futaba Tx.

[@nick_doutrnz_entertainment]

I have the Spektrum iX14 Tx and this Rx. I got it to bind once with a test plane just to test it. But, now, it will not bind to anything. I have not changed the radio, I just created a new model. I set it up, every connected but it will not bind. There is one red static light buy channel 1 and then the blinking red light should be on for binding in the lower right. When I bind from the Tx, I can see the red flashing light blink slightly off rhythm for a fraction of a second, then blinks normal and the bind fails. Can you factory reset the Rx? Has anyone else come across this? I only have this one Tx and it works fine with the rest of the spectrum Rx's I have. I don't have any other type of Rx that doesn't work. I'm a bit disappointed. I really want this to work.

[@williewideback]

hi, i just answered your question on Motion RC, i have the iX14, I also changed Planes and didn't have any problem, not sure what the issue may be on your end

[@mytubehkjt]

Does the energy meter do 6s? The instructions seem to suggest only 5s.. Many thanks if you can confirm for me before I buy.

[@ernestostrman5147]

I have 2 7ch in planes i didnt fly yet

[@itzjoeylo4501]

Futaba, Sorry…!

[@Backupaccidk]

Could I use this for the al37?

[@MotionRC]

yep, can use it with any plane and long as you have a compatible Transmitter

[@Backupaccidk]

@@MotionRC would you consider the al37 easy to fly if I’m flying an apprentice now or should I get the banshee then move up to it

[@MotionRC]

Tough to say. Its a commercial jet so in theory, it is easy to fly as your only really flying circuits, but it is an EDF jet which you would probably want to start with a Banshee type jet to learn jet tendencies. Namely the stall. Unlike a prop plane in which thrust is almost immediately acheived by raising your throttle, a jet takes more time. So the AL37 if flying too slow in a tun for instance, a newbie might not understand and be late on the throttle to counter etc. All comes down to your confidence as a pilot.