Another way to stop a nitro engine is to let my friend tune it. Might stop so hard that it’s permanent lol
@AdamDrake3 ай бұрын
LOL!
@klgood72003 ай бұрын
😂😂
@rutbuster13 ай бұрын
I use both methods but always make sure it's at BDC to cool. Good tip for those that don't know.
@davidaarons24883 ай бұрын
I do the same, also mark the flywheel with a Dremel grind mark when I put clutch on motor. Thanks Adam
@kevin_19793 ай бұрын
I used a yellow paint marker on mine because I didn't want to possibility effect the balance.
@davidaarons24883 ай бұрын
@@kevin_1979 I'm only taking just enough to see it, I wouldn't worry about it effecting the balance, not enough to even weigh.
@AdamDrake3 ай бұрын
Great tip!
@baggszilla3 ай бұрын
What about pinching the fuel line? I heard it's bad to because it leans out the fuel and could hurt the lubrication of the engine.
@doingstufforatleasttrying48433 ай бұрын
I always pinch the fuel line. In fact it has a clip that is always closed until I open it. I have never had a problem in 25 years…
@AdamDrake3 ай бұрын
Agree.
@kanenstuff3 ай бұрын
What about pinching the fuel line? This is a good tip from a pro and will give this a go cheers.
@AdamDrake3 ай бұрын
Yes, this will work as well, but I don't like running the engine dry personally.
@kanenstuff3 ай бұрын
@AdamDrake OK thanks for your reply enjoy your day.
@ShasOAunLa3 ай бұрын
what's about turning the glowplug loose slightly and tightening it down again?
@danatinnel37583 ай бұрын
Ooooh this is good video for the newest of us!
@fuzzfreak19673 ай бұрын
Hi Adam, I was wondering what is the best way to get the residual fuel out of the engine when you are all done running?
@AdamDrake3 ай бұрын
You can run it out of fuel by idling the engine, but I don't prefer this method because it's basically running the engine dry. I just stop the engine and then use our after run oil.
@fuzzfreak19673 ай бұрын
@@AdamDrake oh yea, you don’t have to worry about the bit of fuel in the engine if you put after run oil in, I did not know that. Thanks Adam 😊
@erikvs1.53 ай бұрын
Last run of day should always shut off by pinching fuel feed line to ensure most of the fuel left in motor is burned. Nitro fuel is methanol based and hydroscopic. Any unburned fuel left in motor will absorb water and will eventually begin to corrode components.
@Gavs_rc_hobbies3 ай бұрын
I use the flywheel method. If I dont have the rubber stop tool, i'll use my walking stick. I personally dont like to use my finger as I have in the past hurt my fingers from the flywheel rubbing skin away.
@AdamDrake3 ай бұрын
Very nice!
@schelleracinginnovations19253 ай бұрын
I use the heel of my sneaker. On a runaway turn it over dump the tank if you can’t use your heel. No skin anywhere near the flywheel!
@AdamDrake3 ай бұрын
This video was intended for general use and shutting off an engine at idle. During a runaway, always use a stopper un the tuning driver or rock.
@franciscovazquez45893 ай бұрын
👏🏼👌🏼👍🏼
@nikolaszikakis10463 ай бұрын
There’s also a third way: to pinch the fuel line
@AdamDrake3 ай бұрын
Yes, this will work as well, but I don't like running the engine dry personally.
@RoryHollarTURTLERCRACING3 ай бұрын
Thank you ………!
@AdamDrake3 ай бұрын
My pleasure!
@michaelhess30123 ай бұрын
This is related but different, i think we all need to tech the new guys and electric only guys how to safely stop a run away. I don't know how many times I've seen new guys grab it to marshal it and the car is screaming and they throw it down and cue circus music.
@jukkaovaskainen3 ай бұрын
👍
@AdamDrake3 ай бұрын
:)
@marcowerner87393 ай бұрын
Never use the finger to shut the engine off touching the flywheel. Never Adam.
@AdamDrake3 ай бұрын
This video was intended for general use and shutting off an engine at idle after a run.
@shanonswafford47293 ай бұрын
Don't use your finger. Your buddy might blip the throttle at the same time. Don't ask how I know.
@AdamDrake3 ай бұрын
Great point! This video was intended for general use and shutting off an engine at idle.
@mugendrewable3 ай бұрын
Finger. Be forcefull.
@tonydetwiler26243 ай бұрын
yep its like a grinder wheel big no thanks
@mugendrewable3 ай бұрын
@@tonydetwiler2624 if it's idling that high in rpm I would suggest you watch Adam Drake's engine tuning videos.
@tonydetwiler26243 ай бұрын
no im talking about if your not putting forrce on it and try to lightly hit it