How to | Solder RC Connectors

[@Jean-MarcFrouin]

Bon travail bien exécuté solide rien à dire...merci beaucoup monsieur

[@nickpacello2597]

I’ve always been intimidated about soldering, but after seeing your video I’m going to give it a try!!! Thanks for the step by step

[@redbanditracing]

Glad I could help

[@Hungrybird474]

Good job 👏. I remember doing this for the esc 5 connector on the max6 and had to use a Vice and squeeze the other half together to set the soldered piece inside the plastic . I could feel them go into place . That was the easiest way for me . I saw some lady do it on KZbin

[@redbanditracing]

If you have the right setup it’s not too bad, a lot of comments have been very misleading. Don’t over solder, and just make sure the connection is tight.

[@KingSlingRC]

Thats how I did my last solder job, guys like to use too much and it ends up looking bad. perfect!!

[@RudyMajid]

Sir. I got some problem. I can't bind my new sanwa m17 2024 to my sledge. Vxl 6s only blinking green. No throttle only steering. Help me sir

[@redbanditracing]

Some transmitters won’t bind to certain receivers, I’m not familiar with a lot of this aftermarket brands. Double check the binding instructions for that transmitter.