How to spool Braid line to conventional fishing reel without slip. DISCLAIMER: PERFORM DO IT YOURSELF(DIY) WORK AT YOUR OWN RISK.
Пікірлер: 24
@420visions4 жыл бұрын
Fisherman and a techy. I see that rasperi pi in the back. My dude!
@nickk61096 жыл бұрын
I use a broken old reel to load the spool line onto first, then transfer the line onto the final target reel but set the drag of the old reel. The new reel then pulls the line hard off the reel and you get a far more compact line lay. Also you can also use water on the braid to help get a compact line lay.
@TheJaichel6 жыл бұрын
Nick K yes i do the same gets the braid tight on the spool much better
@mellemauotord7254 жыл бұрын
you just gave me good advise. thanks!
@rassieerasmus25646 жыл бұрын
the ultimate back lash guide
@TheIconicFisherman Жыл бұрын
Not necessarily, the original way Braid was put onto spools when it first came out was with electrical tape. Then people started using mono backing to save money because they realized braid is expensive and that they didn't need a full spool anyway.
@mellemauotord7254 жыл бұрын
thank you for good advice!
@eliasburnett61298 жыл бұрын
good tutorial
@jamesthegamer120yang24 жыл бұрын
You said sis
@greygraham53616 жыл бұрын
Great video
@ventzxvx19006 жыл бұрын
This helped thanks😊😊👌👌
@colinmcneer44126 жыл бұрын
Good tutorial
@MyZeekster7 жыл бұрын
nice video... appreciate it... but whats an elechit tape
@herminiagonzalez22877 жыл бұрын
he means electric tape
@ahndeux6 жыл бұрын
This is NOT how you want to wind braid. Please don't follow this guy's instructions. You don't need tape if its done right. The key is to leave a tag end about an inch long of braid and to SLOWLY wind over that tag end at HIGH PRESSURE when you start. He is way too loose and it would cause nothing but problems later when the spool slips. Salt water will get under the tape and corrode the spool. I even put in a light coat of corrosion protectant on the spool to protect it.