How to take apart any lowrider hydraulic gear head and swap seals

[@normabarriga893]

LowLows & More..we thank you for demonstrating our SEALS in your video..we stand BEHIND our products...and as always...STAY UP...STAY STRONG...and LOWRIDE FOREVER!!!

[@alonsonavarro2126]

I suggest always using bearing grease to grease up the seals when you're installing them that way they have no chance of ripping as you're putting the bolts on.

[@arnaldogonzalez4567]

Just came up on your channel, like what your doing homey. You now have a new scriber.

[@lowlowsandmore]

Thank you

[@arthurarredondo1712]

Quick ? I bought them presto hi #9 gears to replace my old ones on my pumps they were fenner gears I was told they are a lot small they are bolted down to the block with 2 bolts I can hold them the same with 2 or we I have to use 4 bolts

[@lowlowsandmore]

In my opinion presto hi gears are garbage, it is ok that 2 bolts hold it on.

[@RS-ot3jh]

I live in Vancouver i just bought a 9# thunder gear head i was watching your video of to replace shaft seal but it doesn't look the same

[@pushharder8952]

I would like to see the presto Hi pump head working install it in a lowrider so i can see how fast it is @ 48V, do these pump heads produce a lot of pressure?

[@nobodyschild967]

The E-seals are a 2parter per..... 1rubber(black) & 1 plastic(white,red,pink, etc.) Would be nice to actually see in detail on how you actually set them. Jus sayin. I remember my 1st gear pump i did i had the seals backwards 🤣🥳

[@NeoB-Lac]

Do the gears double as impalers for the fluid?

[@kaygeehtv174]

What happens if you put the rubber seal down first and then the plastic inside I noticed on my Marzocchi that’s how it looks like it came I’ve been blowing the bacc seal never the front after 5 or 6 up and down taps of the switch bled lines same problem every time

[@Lpbarron]

How you know when the gear is bad

[@slickpanther06]

What’s your opinion of the high presto gear for a lay n play set up on 48 volts. Want to get #9 gears.

[@samuelbermudez2971]

My pump wont build pressure. Has oil

[@lowlowsandmore]

Is the O ring between the block and the gear in good shape? How old is your gear? Did you bleed your lines?

[@NUNNIE103]

LowLows & More! Same here got new shaft seal but nothing

[@lowlowsandmore]

@@NUNNIE103 how about the ORing that sits between the gear and the block?

[@NUNNIE103]

LowLows & More! I’ll go get all new seals and try to change than all out to see

[@samuelbermudez2971]

I swap pump out .

[@nikhorse]

Is IS6 Rockford a #9? Thanks

[@lowlowsandmore]

Yes

[@nikhorse]

Thanks for your help. I appreciate all that your doing.

[@GBD85]

Who sells #5 gears?