Basic set up using jumper cables 2 6volt batteries and a 6 gauge battery connector
Пікірлер: 56
@lindalheureux17754 жыл бұрын
thank you so much...I had bought a golf cart for my mom who will be 92 this August and asked my brother for help testing but he did not want to help ran across your post here and was so glad I could check the motor myself everything worked on the motor tires went around thank you so much
@murrayseamon1281Ай бұрын
Thank you so much for video. Just bought a ezgo golf cart and wanted to test the motor but didn't have a clue how. But now I do and was successful on testing my motor. Thanks Glenn
@williamcomer73105 жыл бұрын
Great video. Was wondering how to test my motor. This made it simple and fast. Many thanks
@terrytodd3669 Жыл бұрын
Good video short and straight to the point very helpful. Thanks friend
@Lando94Ай бұрын
Thanks this helped my jump box would only read fault I gave this a try at least I can say my motors not the issue now 😅
@Jodyfaye176 жыл бұрын
Thank you for this video. My tires started spinning.
@markjohnson98853 жыл бұрын
Hope this can help someone else. I just got a 2006 Yamaha G22E. It had been setting in a barn for 5 or 6 years, so the batteries were shot. Before I spent $700 to $1200 on batteries, I wanted to test the motor to make sure it hadn't died. This video was as close as I could find for my Yamaha, but it contained everything I needed to figure mine out. The Yamaha motor is marked F2 (small post) F1 (small post) A1 (large post) A2 (large post) By jumping A1 to F1 and A2 to F2 then appling 12volts to A1 and A2 (polarity doesn't matter), the motor spun, much to my joy!! Now, Sam's Club has 8volt Duralast batteries for $109 each, I don't know if I'll be using it often enough to warrant more expensive batteries.
@itsathaithing Жыл бұрын
Hey man, thanks for the video. This is exactly what I was looking for. I am going to go test my motor now. I got a cool 2002 TXT for $260. If I can get it going I scored.
@glenndillman9339 Жыл бұрын
Good luck!
@CharlesKeith-mr4on2 ай бұрын
Thanks. Just what I needed. Now I am on to the controller just like you. Any links to test and troubleshoot controller?
@kaptkrunchfpv Жыл бұрын
Thanks for the info, what did it end up being?
@garryhulgan52672 жыл бұрын
its called a shunt motor, separate excitation , you have a enclosed motor, carbon tracking is happening, you have to tear it down, clean the brush holders, did you check the brushes
@NorfolkBroadsForum Жыл бұрын
Its a series motor not a shunt motor, the wiring would be different if it was a shunt
@2turnt2593 жыл бұрын
Thank you man hope you have a great day!!!
@joseosito19822 жыл бұрын
La verda muy buen truco me funciono al 100 👏👏👏👏
@johnnyt6216 жыл бұрын
what ended up being the issue? I'm in the same boat.
@xredman0023 жыл бұрын
we'll never know
@chensler682 жыл бұрын
Well my wheels are spinning.so motor is good.😃.. controller might be the issue 😡 .... tanx for vid.. good job
@glenndillman9339 Жыл бұрын
Most of the times its the solenoid or the forward reverse switch
@stanveal84102 жыл бұрын
Is the motor testing for F&R. Cart only goes in F. Have checked the F&R switch wires to be good.I have traced the wires from the control board and tow switch to be correct. Solenoid resistor heating up when connected to the large post of the solenoid. Thanks
@jeffellermeyer45174 жыл бұрын
So what was it? Was it your controller? Or?.
@madymade2985 жыл бұрын
It can also be the ITS sensor or micro switch next to the sensor.
@x2malandy3 жыл бұрын
Cool idea. Can a guy jump over sensor to test or check continuity?
@BAZOOKIE58672 жыл бұрын
Is there an ITS sensor in a 1990?
@jessestone46502 жыл бұрын
Nice tutorial
@hotrodgs4 жыл бұрын
Why do you use only 12 volts to test the motor ? Why not use full 6 volts ? Where does the test wiring Schematic come from ? Not to be a pia , just curious.
@pilotrserra Жыл бұрын
Hey Glenn, I have the exact same exhorted golf cart and setup (I.e. controller, f&r switch, etc.). My controller clicks on, but wheels do not turn. Motor is good. What was the problem with yours? I’m still stumped.
@glenndillman9339 Жыл бұрын
I replaced the motor and updated the solenoid and F/R Switch to heavy duty.
@victortorres-hz9tu4 жыл бұрын
Hi glenn i have the same ezgo car. Mi cuetion is way never charged if o have new charger an all batteries is newone to the car no used for almost 2 years
@DBPR015 жыл бұрын
So did you ever figure out the problem?
@kschwanify6 жыл бұрын
Did you ever find out how to fix it?
@CMichaelLyle3 жыл бұрын
Release parking brake too
@barryjohns1965 Жыл бұрын
Thank you
@danielbrothers3 жыл бұрын
it might be in the reed switch inside the battery charger female plug receptacle
@nadiaberezin81173 жыл бұрын
that's a common problem
@crisprtalk6963 Жыл бұрын
killer!
@stevenb3203 жыл бұрын
Igniting, control box or inductive Throttle sensor
@gvccorrado115 жыл бұрын
Right tire spins in reverse. Left tire doesnt spin at all. I'm hooked up + to F2. And - to A1. On my EZGo(1983) I have A1 A2 F1 F2. If right spins in reverse am I good?
@gil53046 жыл бұрын
Do you know if it will be the same procedure with a 48 volt? Thanks
@offgridcabinaddict63144 жыл бұрын
This will work on a 48v motor I just did it on my bad boy Buggie which is 4WD so it has 2 motors both worked so I know now it’s the controller that’s bad. I was looking for a test on 48v too. So to help anybody else out I just wanted to say that yes it does work on 48V as well.
@freshmaker53 жыл бұрын
@@offgridcabinaddict6314 I’m have a problem with my bad boy buggy. Anyway to contact you to see if you know what it is? I have done lots of tests.
@Houseofkartz6 жыл бұрын
What was it bud?
@STORMARAGING5 жыл бұрын
And the broom...?
@noellwilson12732 жыл бұрын
I’d connect to the battery posts if possible. Not the threaded attachment bolts. You’re going to mess up the threads.
@glenndillman9339 Жыл бұрын
its fine
@mayobabble Жыл бұрын
We are having a problem were it only works in reverse.
@glenndillman9339 Жыл бұрын
I would get a new motor- they run around 400 to 500 bucks...
@atypicalhiker5 жыл бұрын
I now know my motor controller is dead
@dannyvanroyjoseph3 жыл бұрын
Only one of my wheels would spin. Is that normal?
@glenndillman9339 Жыл бұрын
depends on what kind of golf cart you have. Most likely not normal
@garryrichard9893 Жыл бұрын
It started sparking
@sharongraugnard19043 жыл бұрын
8
@festus19645 жыл бұрын
Garbage! This configuration doesn't work on my EZGO TXT. Tie both 1's together and hook the negative jumper cable to them - then do the same for the 2's with the positive cable.
@breeze7875 жыл бұрын
So technically you are just throwing parts at your EZGO golf cart? But . . . . you managed to find out how to test the electric motor which we have to give you kudos for that. But in trying to figure out your problem you changed the solenoid, batteries & other parts? In the same manner that you discovered how to test your electric motor that is the same thing you do with all suspect components. Find out how to test the components before replacing them. Throwing parts at your problem is a mistake and huge waste of time and $$$$$. Finding out how to test your components 1st to eliminate or suspect the bad component is the more proper trouble shooting technique. Eliminating the electric motor as a possible problem by testing it first is the correct troubleshooting method. Imagine if you paid the $700 - $1000 for the electric motor and swapped it out for the one you tested to be good what a waste of time & effort. You already changed up the batteries which was a huge $1000 troubleshooting mistake. Funny that's how most fix their automobiles. Thanks for putting this up.
@frankbinsley62212 жыл бұрын
Youre absolutly correct. I will say i have been guilty of this same thing more than id like to admit..proper testing will save you so much stress and money