HOW TO TURN OFF TOYOTA TRACTION CONTROL LIGHT | HOW TO RESET TOYOTA COROLLA TRACTION CONTROL LIGHT

[@elpajaro76]

I was having the same issue after a check light on for ignition coil came on I corrected that problem. Then I couldn't figure out how to get that light off. I was going do that paper clip but then I came across your video and I decided to try my scanner. I dont much about scanner but it worked... light went out to see what happened later thank you great video

[@carloscampos5191]

I have problem 2001 I set the rear abs sensor because light was off in and on give a tip how reset

[@BrandonLewis566]

@straightouttacontent I’m having a problem with my 2015 Toyota Corolla S. I replaced both cv axles, motor mounts and sway bar links. Now I have a code P0720 output shaft sensor. I’ve replaced the sensor but can’t get the code cleared. That same traction control light is coming on and it’s like in a limp mode. Can’t go over 40mph and car doesn’t shift.

[@Racecar564]

Hello! I have a question as a fellow 2016 Corolla owner with a bad ABS wheel speed sensor. Could the yaw sensor issue be avoided by disconnecting the battery first, then performing the sensor replacement, putting the wheel back on and then reconnecting the battery? If someone might know, please educate me. Thank you!

[@Pushallmighty]

I got the same slip light after an alignment, tried using my scan tool only to find out my brother had taken it and since im impatient i went the paper clip method and it worked 😅(dont recommend too risky)

[@GoogleilearnBlogspote]

Thank you men , can I get Peter contact I am in Houston

[@joslinn_erm]

Good advise thanks 🙏

[@citlalmitlmexica4070]

So i need that device in order to get rid of that light, thanks

[@rakibchowdhury5273]

Do you know how remove the speed limits because my Corolla top speed only 114 miles should go more because speed meter said 140 pl advice me

[@StraightOuttaContent]

No clue. Im pretty sure its not safe to go that fast in a corolla lol

[@donnybergwow]

You would have to remove the governer in ig

[@davidnunezmontecarlo5422]

Hello sir I just did my transmission on my Toyota sienna 2011 before I had the transmission rebuilt and the transmission went out the check engine came on traction control came on. And after the transmission was done check engine was off traction control was off but the transmission guy drove it and not figure out why the traction control turned back on. Is this the same that you're doing on your computer. If you could give me some kind guidance sir I appreciate it thank you for your video.

[@bekimuka7689]

Yes, but traction control is ok after that, or we need to replace the sensor...light may be gone, but the problem is still there...😮

[@fatawujafaru6031]

Wow that's great

[@harema.ali6518]

Thanks

[@jeremyhurd8771]

In my automotive class we use to use paper clips or a wire to see codes there was scanners but at the time you could borrow the teachers😂😂🤣the good old days.When we were taught we had to work with what we got.It was a joke Don't use paperclips.Go to a mechanic heads down .In my town a the og mechanic s are gone thanks for the video.I bought a 99 Avalon and can't get it off well never unhooked the battery plus learning everyday.need something call me

[@MrAndyvaltierra]

What is Peter's contact info...?

[@StraightOuttaContent]

are you located in the Houston area?

[@lewisnunu8451]

This is a Kikuyu guy😂🤣🤣