How to use a Slip Roller and Roll Sheet Metal

[@GameBacardi]

Found finally good video of this, thank you

[@va7entino46]

Thanks man , im doing lots of exhausts for my bikes by hand and its painfull and slow and never perfect but with this it will be easier

[@JetManJoe]

Best of luck with that 😁

[@Skylos100500]

why is there a gap in the shaft ?

[@ps50k0]

Please make more vids.

[@CarholicBG]

Hi, as far as I can see you could form a perfect tube with a slip roller. Is this correct?

[@JetManJoe]

Hi CarholicBG, you can roll sheet metal into a cylinder but are limited to a certain diameter. With my slip roller the rollers are 60mm in diameter so the smallest I could probably form a cylinder down to would be around 70mm. Also thickness of the sheet metal is restricted to 1.6mm but with a small piece I could roll 2mm.

[@jimbasara]

Thanks for the video. I'm planning to purchase a roller. What brand is that?

[@JetManJoe]

I bought my slip roller from this link at Paramount Browns. Its rated to roll 2mm mild steel and I think its a great unit for a small workshop. www.paramountbrowns.com.au/products/slip-roller-1250-x-2-0mm-pedestal/

[@blablableep6811]

Could this form truncated cones?

[@JetManJoe]

Yes, see my other videos

[@blablableep6811]

@@JetManJoe thank you