How to use DSO138 Oscilloscope?

NOTE: Skip to 07:00 for How to use Instructions.
Time Stamp:
00:18- Intro
00:30- Unboxing
01:00- Content inside the package
01:59- Manuals
03:30- Specifications
05:06- Power Supply and Probe
07:00- How to use Instructions
DSO138 Buy link: bit.ly/37URFES

[@THEELECTRONICGUY]

NOTE: Skip to 07:00 for How to use Instructions. Time Stamp: 00:18- Intro 00:30- Unboxing 01:00- Content inside the package 01:59- Manuals 03:30- Specifications 05:06- Power Supply and Probe 07:00- How to use Instructions

[@ckeisler]

Thank you for doing this. It was very helpful to me as a beginner.

[@sanjivsharma5966]

i was also confused about measurement mode.... sometimes it popped up sometimes it didn't.... and i thought my dso138 has problem... but this video helped me figure out the issue

[@Dennis-mq6or]

The scope would have performed much better if you read the instructions on how to properly initialize and calibrate the scope. Once you calibrate so it knows where ground is, and zeros out any offset, your trigger will work much better. Also, your vertical display was way too noisy. You need to shield the bottom of the board, and if that does not make the vertical hash go away, I understand that some circuit boards needed a little ground reinforcement to lower the resistance of the ground path between the processor ground and the input ground.

[@rizvanrazi4698]

Can we check 24v pwm signal with this device

[@lance16O1]

What did I break if I gave it too much voltage?

[@powderslinger5968]

The 'scope.

[@jansmejkal7650]

Vem si na to rukavic