How to use the xTool P2 Automatic Conveyor

Рет қаралды 2,574

Monkey Woodworks and More

Күн бұрын

Пікірлер: 21

@chiokeelmore6028 3 ай бұрын

This video is super helpful. Thank you so much.

@MonkeyWoodworks 2 ай бұрын

Glad it was helpful!

@penworks9983 6 ай бұрын

I don't have a conveyor, so I will live through you! Lol 😆 looking forward to your Ultra review!

@MonkeyWoodworks 6 ай бұрын

hah! Live away Pen!

@Pa_Dave 4 ай бұрын

THANK YOU so much, your videos are great!

@Pa_Dave 4 ай бұрын

So..if the conveyor is not same level as P2 ..how u suggest fix that?

@MonkeyWoodworks 4 ай бұрын

If it is too short, you can put scrap wood under the feet of the conveyor to lift it up to level. If it is too high, you will need to figure out a way to either lower the side tables supporting the conveyor or raise the P2 a little.

@MonkeyWoodworks 4 ай бұрын

You're very welcome!

@Explosion85 6 ай бұрын

Great video! I discovered this while trying to find a new pizza cutter and I think this settles my decision!

@MonkeyWoodworks 6 ай бұрын

Now I gotta know, which pizza cutter did you go with???!!!

@kaizhongryan 3 ай бұрын

Thank you.Can you tell me the length and width of the materials you usually process?

@MonkeyWoodworks 2 ай бұрын

It varies by the customer's requirements

@ShyneflowLC 6 ай бұрын

I really have to give mine a shot haha

@MonkeyWoodworks 6 ай бұрын

Do it!

@deannahepner9355 29 күн бұрын

Do you mind explaining what you have your laser sitting on? I have limited space and that looks like i might be able to make that work in my space?

@MonkeyWoodworks 27 күн бұрын

Ot is a marketplace find. I talk briefly about it in my riserbase video.

@rickpouley7561 6 ай бұрын

Nice sign.. I just have a small question about your table extension for you P2. I have the P2 also, and have purchased the Conveyor System, but I have not had a chance to use this so far, but I am wanting to add on to my bench and I just wanted to know how far did your make your table extension? Thank you...

@MonkeyWoodworks 6 ай бұрын

I made a quick knock down setup for my P2. My infeed and outfeed tables were made by cutting a 12" x 6ft board in half. If you check out my video of putting together the conveyor, you can see how I set it up.

@rickpouley7561 6 ай бұрын

@@MonkeyWoodworks Thank you!vI will look up your video! Have a great weekend..

@MonkeyWoodworks 6 ай бұрын

@@rickpouley7561 same to you. Feel free to reach out if you have any questions

@rickpouley7561 6 ай бұрын

@@MonkeyWoodworks Thank you again!