How To Wire 6 SVC Speaker's In Parallel! MUST WATCH! Upgraded My Garage System!

[@alanstant9356]

That's very awesome, my friend. Teach the younger generation on the how-to's lol.

[@Memiselphi]

That's the plan!

[@natesomers5387]

Man with a solder gun you could run through speaker in seconds buddy but really loving the content keep it coming road to 100 k let’s go!!!

[@Memiselphi]

As a person who’s not necessarily good at soldering, I definitely didn’t want to apply a more permanent method for a temporary install. I plan on splitting the speakers in 2 half’s. 3 on the left side and 3 on the right side.

[@allenpavlicek561]

@Memiselphi Good video….you should know what ohm speakers you have but to get the final impedance you’re showing they would all have to be 4ohm, not 8. I may be wrong but that’s what I see, just my two cents.

[@Memiselphi]

@@allenpavlicek561 I showed the ohm chart from the website on screen.

[@scamchan]

Ever thought about adding a switch so you could change up the ohm load on the fly?

[@Memiselphi]

@@scamchan no. I’m not sure on how to do that.

[@scamchan]

@@Memiselphi I wired mine to a switch it works great.

[@JasonWW2000]

What would be the purpose of doing that?

[@scamchan]

@@JasonWW2000 Well if you have an amp that can't do a low ohm load you don't have to rewire for it. Then there are cases where people claim that higher a ohm load has better quality of sound. You know those cheap A/B amps can't handle those low ohms without heating up like crazy.

[@scamchan]

@@JasonWW2000 I bought refurbished kicker amp that was supposed to be 1 ohm stable. Soon as I dropped it down to 1 ohm it went crazy into protect. Before then it was working like a champ a 2 ohms. Swapped that out to a skar and it works fine at 1 ohm. I also had a sound stream that came out of the box I installed and it was powered up into protect so I had to return it. So yeah having that switch you can test things at different ohm loads.

[@scamchan]

Do you sell those speaker boxes?

[@Memiselphi]

@@scamchan I haven’t. I just been having them for personal use. I bought a few of them because I likes the look. I don’t know if I’ll be able to make profit off of them if I wanted to sale them.

[@scamchan]

Always better to cut the wire too long than too short.

[@scamchan]

Are those 2 ohm speakers?

[@Memiselphi]

@@scamchan 8 ohm.

[@scamchan]

@@Memiselphi Connecting three (3) 8Ω speakers in parallel is a 2.7Ω load (8 / 3 = 2.66) How you get .5?

[@Memiselphi]

@@scamchan and I connected 6, which is supposed to be 1.33. I don’t know! I’m lost myself. They are all labeled 8 ohms.

[@scamchan]

@@Memiselphi Six 8 ohm speakers in parallel would equate to 1.33 ohms

[@scamchan]

@@Memiselphi something off on those speakers