HP Tuners Burble and Pop Tune

  Рет қаралды 7,276

PapaTon

PapaTon

Күн бұрын

Пікірлер: 17
@Shadlow_12
@Shadlow_12 Ай бұрын
Would this work for eco boost mustang and does anyone have the tune for pop
@jacobsjafir9332
@jacobsjafir9332 6 ай бұрын
do you need a unlocked pcm?
@jacobsjafir9332
@jacobsjafir9332 7 ай бұрын
do you know if Hp tuners works on a jeep grand Cherokee?
@PapaPapaTon
@PapaPapaTon 7 ай бұрын
The supported vehicle list is here: www.hptuners.com/vehicles/#supported-vehicles
@Greeneyes1218
@Greeneyes1218 Жыл бұрын
I’m new to doing tune but would this be good for dodge challenger 5.7
@PapaPapaTon
@PapaPapaTon Жыл бұрын
The concept remains same. Keep fueling on deceleration with negative spark timing. DFCO should be in most of, or if not all, factory tunes and is the place to start.
@Upyours2253
@Upyours2253 Жыл бұрын
Would this work for a v6 camaro
@PapaPapaTon
@PapaPapaTon Жыл бұрын
Assuming HP tuners supports v6 Camaros then yes in theory it should work. The principle is the same, just need to modify the numbers to match the application.
@bandzzz300c
@bandzzz300c Жыл бұрын
would this work for a 1900 chrysler accord ?
@rileyh.4554
@rileyh.4554 Жыл бұрын
If you dont know you probably shouldn’t attempt
@BALJITSINGH-ez4nk
@BALJITSINGH-ez4nk Жыл бұрын
will it burn more fuel?
@rileyh.4554
@rileyh.4554 Жыл бұрын
Yes
@alagy
@alagy Жыл бұрын
I think you're doing it wrong,DFCO should be disabled for pops or back fire to work. If DFCO is enabled it will cut off fuel on decel which is something you dont want
@PapaPapaTon
@PapaPapaTon Жыл бұрын
Its not that simple since DFCO encapsulates a number of different tuning variables, and in my case and on/off option does not exist. You can tune it out by setting certain variables to be unachievable but then the tune will never leave the spark run table and you're still stuck with no pops and burbles until you modify the spark run table to have negative timing in the right areas when off the gas. The alternative is if the tune goes into DFCO you can easily set the timing negative and set the DFCO Fuel Cut Delay to the max crank references at 65,535 which gives about 11 seconds of pops with a 58x reluctor at a constant 6k rpm.
@sidvicious01
@sidvicious01 9 ай бұрын
​@@PapaPapaTon will the negative spark make the pops louder 🤔
@PapaPapaTon
@PapaPapaTon 9 ай бұрын
@@sidvicious01 'more' negative spark timing will. Try -5, then -15 and you'll notice a difference.
@sidvicious01
@sidvicious01 9 ай бұрын
@PapaPapaTon oh ok I got small pops now but haven't mess with the spark tables none I think at the start they are -3 but then go to positive 5 or so
Gen 3 LS Swap Tune DIY with HPTuners
24:51
Matt Sanford
Рет қаралды 29 М.
Burble Pop Bang Tune Version 2! - HP Tuners
8:19
PapaTon
Рет қаралды 1,9 М.
BAYGUYSTAN | 1 СЕРИЯ | bayGUYS
36:55
bayGUYS
Рет қаралды 1,9 МЛН
Quilt Challenge, No Skills, Just Luck#Funnyfamily #Partygames #Funny
00:32
Family Games Media
Рет қаралды 55 МЛН
Burble Tune || EXPLAINED
8:33
MZopyrus
Рет қаралды 92 М.
Guide to Tuning VE on early GM Cars
27:54
ChopperDoc181
Рет қаралды 62 М.
CNCPS v6.56 Update (Part 2)
23:33
RUM&N NDS Professional
Рет қаралды 197
Google’s Quantum Chip: Did We Just Tap Into Parallel Universes?
9:34
MAF Tuning and Scaling, Tuning Series Vol. 3, HP Tuners
22:02
Goat Rope Garage
Рет қаралды 219 М.
Tuning for Emissions with Headers or Exhaust
6:31
PapaTon
Рет қаралды 302
Pops and Bangs Tune How To, Get Your Burble On!
8:14
Goat Rope Garage
Рет қаралды 80 М.
Burnout Mode… ENGAGED! Gen 3 GM How-To using HPTuners
12:48
Matt Sanford
Рет қаралды 20 М.