Hp Tuners MPVI2 Pro Link and AEM Wideband X series How to Setup To Log Data

[@dennisk8134]

Exactly the video I needed. My graph has just been blank for days. I searched and searched but couldn’t figure out what I was doing wrong. Nice work man, thank you for the information!

[@BurninGas8.1]

I like helping people thanks bro hit subscribe

[@hellcat7978]

Sick I love seeing the progression of this truck

[@kamrenwood1894]

Most helpful video I’ve come across on this topic. Thank you for sharing your knowledge with us! 🙏

[@BurninGas8.1]

Thanks buddy

[@derekgray1633]

this was very helpful got my gauge working on my HP tuners software

[@BurninGas8.1]

hit like and subscribe for me buddy glad I could help you

[@SpAwNxtRaPxkINgx]

There a better way to populate that data so you can copy it over in to the maf to adjust the fueling also make sure close loop is off

[@joseiturbide4175]

Do i need to get other program or update besides prolink adapter? Thanks

[@BurninGas8.1]

just do your updates through hp tuners

[@chinoperez422]

Updates on the scanner or editor ?​@@BurninGas8.1

[@chvypowr93]

What math parameters did you put in for the eq error ratio? Ive got my wideband ran threw pro link and eq ratio on mine and it's not pulling any data in my afr graph.

[@BurninGas8.1]

did u watch the video thoroughly it should be all explained...

[@bryanblake4341]

@@BurninGas8.1 yes it seems you talk over it beefily but setting up the afr error math is my issue.getting it to go from volts to afr. ive transformed the mpvi-wideband channel to show afr instead of volts but when i crate a graph nothing shows but because its trying to read volts lambda.

[@kennedywong9854]

Using aem 30 4110 gauge and there only, black, red, blue, and white. The pro link + have blue, black, red, yellow, and orange. How would wire this?

[@BurninGas8.1]

I can’t honestly tell ya I’ve never used that guage

[@BurninGas8.1]

Should only be one wire that you hook to pro link if I remember right

[@codywright4910]

So this is the graph that you will attempt to fill in using various loads and speeds …. Once the graph is filled in you would then compare it to the VE table and try to lower it cell by cell … I am guessing you would want the numbers to read 0 all the way across

[@haroldpowell]

do i have to be connected to truck to find air fuel ratio comanded i tryed without but dont see it its a 2003 gmc 6.0

[@BurninGas8.1]

need to be connected probably running and make sure its on your channel list

[@haroldpowell]

@@BurninGas8.1 could i email u a log to see if i have everything set up right ? im new to tuning with a wideband