I haven't had a successful 3d print in 4 months

3-D printing is such a frustrating thing

[@jamiepowell3405]

Damn sorry about your problems with that shit brother. Thanks for the heads up. Hope the new part works.

[@brianlewis6926]

Thanks for the heads up. I've been wonting to get one but not sure what to get

[@TheFantasticJunkyard]

Check the operating temperature on your resins and then the the temperature of the room its operating in, to make sure its not too hot or too cold. The resin (not the printer) will fail if the temp aint right. Resin printers are a lot of work and not for everybody.

[@richardepps8500]

I got a anycubic mono 4k and I've never had a problem with it. I even scratched the fep sheep at the bottom of the cat and it prints fine. Even while I'm typing this it's printing some of the little tabs that go on an outlet timer for a lamp. You must have just got bad luck with resin printers