IDS X-Series Programming - Stay Zones

IDS X-Series Programming Stay zones #xseries

[@AllanMcPherson-z7y]

thanks will test it to night

[@nombulelomthombeni4679]

What is the error if red flash flickers continuously? How does one stop it from flashing while unarmed.

[@ids_101]

Hi, Flashing red LED means there is a trouble on the keypad (Low battery, Siren Trouble etc.).You need to hold down the number 7 key on the Keypad and it will display what the trouble is. once resolved the LED will be solid

[@previnvandayar2560]

Hi. How do you move a zone from one partition to another

[@ids_101]

Eg. Moving zone 3 from p1 to p3, You will need to do the following Enter the installer code * Enter 201 * for p1 Enter 3 * for zone 3, zone 3 should be Y, press * again to make it N Enter #, then press 203 * for p3 Enter 3 *, zone 3 should be N, enter * again to make it Y. Press ## to exit

[@previnvandayar2560]

Thank you for the reply, however I don't have the installer code

[@AllanMcPherson-z7y]

hi how can i use the diffrent stay zones

[@ids_101]

Hi, on the panel you can have up to four stay profiles, for example, 1 profile could be for when you sleeping, you arm the doors and rooms that you want secured but leave your bedroom and kitchen or bathroom bypassed for example so you can wake up drink water or use the bathroom at night

[@ids_101]

Another profile would be for when you in the lounge but you want the other rooms to be armed but not the lounge or when you leaving kids ik the house and you want them to stay inside, you can bypass the whole inside of the house but leave the doors armed

[@AllanMcPherson-z7y]

Thanks how do I change between stay zones so when I push number 5 and hold it stay arm number 1 is activated but I would like to us stay 2

[@ids_101]

there is 3 ways to do it: 1. If you press and hold 5 by default it will arm profile 1, if you press and hold 5 again it will arm profile 2 and disarm profile 1. 2. You can select the default profile before arming by holding down the mode key, scrolling with panic to stay profile then pressing star to enter then pressing the profile number then * to make it default (2 * here to make profile 2 default) then whenever you press and hold 5 it will arm profile 2 first, then pressing and holding 5 again will arm the next profile. 3. If you have the installer code, you can program that whenever you hold down 5, the keypad will always ask you which profile you want to arm.