If You Have A Boost Leak On Your VR30 Watch This

[@ZillaFullBoost]

I'd like to know how many people had a vacuum or boost leak. What was the cause?

[@WarriorStrengthGym]

Bro me and Hussain are literally trying to find my vacuum leak right now.

[@ZillaFullBoost]

Hopefully you do my man.

[@BoostInMotion]

Get them likes up

[@B58korge]

I have an Oil catch can with a breather. I didn’t experience any turbo leaks until it was installed

[@ZillaFullBoost]

Probably leaking from the can. Install 1 way valves on the lines and see if that helps.

[@dannyp4310]

Hey Zilla, great video. Was wondering what heat resistant tape you have in your IC’s

[@ZillaFullBoost]

Hey danny thanks. I applied those because I have an interchiller. If you don’t have a chiller it will probably heat up the temps more.

[@heemdollas8016]

Great video once again brodie

[@ZillaFullBoost]

Thanks homie

[@macturbo1z754]

Good info bro. Can you do a video on the DIY intakes??would really appreciate it

[@ZillaFullBoost]

Coming soon. Ima try to do it this week. If anything it will still be in the engine bay. I’m going back to the dyno this weekend if I install the intakes to compare HP.

[@macturbo1z754]

@@ZillaFullBoost it is going to be the customs 3” intakes you talked about on ig?

[@angelboyvlogs9092]

Appreciate this

[@ZillaFullBoost]

Appreciate you watching and leaving a comment 🙏🏽

[@slowvr30]

I see you have those DYI intakes on your Q! Did you have any issues with them popping off? No matter how tight and how good I position the clamps it seems like the intakes wanna pop off. Also, on my drivers side, the top of the intake hits the hood when closing. Did you have to cut the inlet more to clear the hood? Thanks for the help!

[@ZillaFullBoost]

I don’t have issues with them popping off but you might need to cut the inlets a bit.

[@dondumay4]

What's the link to the diy catch can?

[@ZillaFullBoost]

Video link is in the description. The OCC in Amazon: amzn.to/3bpj4Us

[@briankress9997]

I have a question for you what do you have on top of your intercoolers

[@ZillaFullBoost]

It’s insulation. It’s intended to trap the cool temps in the IC’s and keep the heat out since I have an interchiller.

[@briankress9997]

Did you do the top and bottom and also where can I buy some of that insulation

[@ZillaFullBoost]

I did the whole thing. amzn.to/33dauqD

[@briankress9997]

@@ZillaFullBoost how many sheets did you purchase Thank you for your time

[@ZillaFullBoost]

I bought the one that came with 2 sheets.

[@619Badar]

What are symptoms of boost leak ? Can I find out from my data logs parameters I can look at?

[@ZillaFullBoost]

For the data log to show it will depend on how bad it is, but symptoms can be rough idle, system lean codes, Short Term Fuel Trims can go negative under boost. You can also look at your wastegate duty cycle target and actual. They should be relatively the same under load.

[@619Badar]

@@ZillaFullBoost thank you 🙏