Ingersoll Rand IR 2236QTIMAX DXS2 vs Matco MT2336 vs Snap-on MG1250

[@terryeffinp]

I have a 3/4 IR, I have always been disappointed by it. I sent it in to have it rebuilt, I have cleaned out the nose on it and re-greased it, deleted the muffler from it. It still is a gutless turd. I was going to replace main bearings in a DD15 this past week, it could not break them loose. The MG1250 didn't even break a sweat. I will be trading in the IR. I should have bought the Snap-on 3/4 the first time.

[@hockenberrytransportllc]

I think I'm more disappointed with it in the context of them pitching this thing as a valid 3/4" when it really isn't. As a half and when the anvils finally become available it'll be awesome to lose less torque with native extensions vs the wobblies we're used to. I have a couple use cases where they'll be super helpful. The 3/4" anvils are basically a waste of time and money, IMHO.

[@terrellscaife2411]

Impressive stuff

[@kyleandres3514]

Get a 1 inch gun that’s not gonna cut it for tires