Install and remove a Roof Top Tent by yourself

[@AbstonsGarage]

Adding the awning to the far outside was too much weight to where it didn't feel safe. I think if we loaded it from the drivers side so the awning was closer to the lift it would be better. Or just doing it without the awning and doing a quick connect mount might be better.

[@Anubixx23]

I am looking at doing something similar for my engine hoist. For the boom extension what angle did you weld the two pieces together at? Thanks!

[@AbstonsGarage]

It will vary based on the roof rack and tent. What I did was measure the roof rack height plus the tent height. Then added about 6”. I took that measurement and used it so the smaller extension would be close to level or flat when lifting if that makes sense.

[@Anubixx23]

@@AbstonsGarage Yes that does make sense, thank you for the help!

[@CustomCraftedDesigns]

Great video, where do you find the tubing that you used? Thanks

[@AbstonsGarage]

Thanks. There should be a local metal shop in your area.. Here in Birmingham there is a place called the Metal Supermarket. You can just tell them to items you want and they will cut to length and have it ready for pickup in about an hour..

[@CustomCraftedDesigns]

Sorry I missed that in the beginning. I have to do this also great idea.

[@AbstonsGarage]

@ lol. No worries. It works great.

[@ghingisoverland6932]

GREAT video, what’s the length the 2x2 1/4”wall tubes used for the boom? Thanks in advance.

[@AbstonsGarage]

5’ for the longer piece and 3’ for the shorter section. We bought a 8’ tube and then just found what we thought would be close to the center of the 4Runner and also somewhat level when over the roof.