Install Honeywell LTE-XA or LTE-XV On VISTA-15P, VISTA-20P, VISTA-21iP

  Рет қаралды 10,324

Alarm Grid

Alarm Grid

Күн бұрын

Пікірлер: 11
@RayChin-qe7ci
@RayChin-qe7ci 4 ай бұрын
Good video. I like how Michael said some people remove the set screw because some people think it is annoying. I agree. I think the set screw is annoying. 🙂
@fasttrackstormcenter
@fasttrackstormcenter Ай бұрын
Big tip, if you mount the communicator near your breaker box, the electrical current that comes in through the wires to the breaker box will help with the cell signal strength especially if you live in an area where cell service isnt the best. My simon xt is mounted in my garage and right in the same spot of where the simon panel is located is the breaker box for the electricity that is connected for my house and my panel communicates via cellular and i actually took the very long antenna and mounted it above the breaker box and to my surprise it keeps the cell signal strength at a good level. It boosted the panels cell signal strength to only two bars which may not be the best but it beats the heck out of having no cell signal strength especially since i live in a rual area where cell service isnt the best
@joshuagriffin2807
@joshuagriffin2807 Ай бұрын
I have run into a similar situation, but it was a faux cell signal it looked like it was 4 bars but was really one bar, If it is close enough to pick up the ambient frequencies of your electrical box it is close enough to catch a possible arc if a surge or house is struck by lighting.
@thomasc3885
@thomasc3885 Жыл бұрын
Great video, thank you!
@Aspen5.7
@Aspen5.7 Жыл бұрын
Good video. Thanks,
@mcalliph
@mcalliph 6 ай бұрын
What about the Vista 50P?
@joshuagriffin2807
@joshuagriffin2807 6 ай бұрын
50P is a very basic commercial system. It does not have the logic to communicate over a Cellular or IP communicator over the keypad connection would require a dialer converter like the LTEM-P with the PRODCM. The 50p is not able to use TC2.
@allanmoulton3745
@allanmoulton3745 4 жыл бұрын
A threaded washer?? It’s called s nut.
@freddaniels8259
@freddaniels8259 4 жыл бұрын
Thanks, Allan. I'm glad that he didn't totally confuse you and you were still able to figure out what he was referring to.
@sms9106
@sms9106 Жыл бұрын
@@freddaniels8259 😁
@Aspen5.7
@Aspen5.7 Жыл бұрын
@@freddaniels8259 Maybe Alan can replay the video a few more times and nit-pick a few other things.
Resideo LTE XA or LTE XV: Troubleshooting "No Signal" Issue
11:33
How Do I Wire The Honeywell 4219 To My Vista 20P?
14:20
Alarm Grid
Рет қаралды 16 М.
❌Разве такое возможно? #story
01:00
Кэри Найс
Рет қаралды 7 МЛН
Cute kitty gadgets 💛
00:24
TheSoul Music Family
Рет қаралды 21 МЛН
Fake watermelon by Secret Vlog
00:16
Secret Vlog
Рет қаралды 12 МЛН
How to setup a VISTA residential panel for initial programming - Resideo
2:46
Resideo Customer Support
Рет қаралды 10 М.
Cellular Communicators That Work With a Honeywell VISTA 20P
7:52
Honeywell LTEM-XV /  LTEM-XA Cellular Communicator Installation
6:19
Alarm System Store
Рет қаралды 3,4 М.
Programming Honeywell 20P -  RF Wireless zones
6:28
Fox Guard
Рет қаралды 23 М.
Addressing a 4219 Zone Expander on a VISTA Alarm System
4:59
Alarm Grid
Рет қаралды 19 М.
How to replace and register a cellular radio on a VISTA alarm system - Resideo
5:20
How Do I Enable the Receiver in a 6160RF?
6:57
Alarm Grid
Рет қаралды 36 М.
Adding Wired Motion Detectors to the VISTA 20P
12:09
Alarm Grid
Рет қаралды 20 М.
basic components required (Vista 20p part 1)
8:55
bounder97
Рет қаралды 76 М.
Programming the 4219 to a Vista P series panel
7:11
Alarm Grid
Рет қаралды 10 М.