Installing a lift on a 2012-2020 Kawasaki Teryx

Link to the kit used in this video (not a paid advertiser)
www.ebay.com/i...
Check out my other videos for this rig and others on my channel
Due to factors beyond the control of Pv2smurf Mechanics, LLC, it cannot guarantee against unauthorized modifications of this information, or improper use of this information. Pv2smurf Mechanics, LLC assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Pv2smurf Mechanics, LLC recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Pv2smurf Mechanics, LLC, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Pv2smurf Mechanics, LLC.

[@megastick9324]

For the washer installation, use a punch or large Phillips. Put it through opposite the bolt. Put the washer on it and push the punch back out with the bolt as it goes in. Everything will stay in place. May take some wiggle But you won’t fight the washers.

[@MetalHeadHippie]

RocOn

[@WarriorCall]

Great video. Very well explained. Thank you. New subscriber

[@pv2smurf]

Thanks for the sub!

[@WarriorCall]

@pv2smurf my pleasure. I bought a 2016 T4 a couple of months ago. I've been doing a few things to it. There aren't many videos on them out there

[@steelernation4818]

Got a 2020 this summer, and I was thinking of doing this.

[@realtreefan]

Thanks so much. Hard to find videos for this kit. Very informative. Much appreciated. Cheers!!!

[@P4NTHERG4MEZ]

What lift kit is this? the link in bio no longer works.

[@pv2smurf]

Just updated the link for everyone

[@fishpony1211]

Nice install!!! What were the measurements after the suspension settled in?

[@pv2smurf]

I'll have to update you on that

[@edmrowiec1936]

Great video. Just ordered the kit. I’m hoping to be able to put a set of 28’s on to get a bit more clearance as well. In tight spaces I have used magnets to hold the washer in place.

[@pv2smurf]

If I went taller, I'd go with wider tires so you don't tip over

[@mataio666]

For the rear, could you have just used the bottom hole of the three on the new bracket? There is one bolt on the bracket and one on the bottom of the shock right?

[@pv2smurf]

You could have but the kit required you to drill a new hole. So that's what the owner did

[@Batablast]

I am looking to get the kit; how has it held up since the installation?

[@pv2smurf]

Since install the owner has had no issue. The owner did go back and reinstall with nylon nuts because he was worried they may back off

[@darrentoth7165]

What was the height measurements after you took e'r for a ride and the suspension settled in?

[@pv2smurf]

I believe, the owner said it settled roughly a quarter to half an inch

[@darrentoth7165]

@@pv2smurf Ok so that was a 3 1/2" lift then? Thanks and great video :)

[@abbyromero6616]

Would this work on a 2021

[@pv2smurf]

Yes. All the suspension is setup the same dating back to at LEAST 2012 (possibly farther)