Installing a loader valve on my Massey 50

[@HomesteadingwiththeHeberts]

As always good job. It is great to hear you talk about things while you work as well. I think you bring up some great points. I look forward to seeing you use this.

[@thomasyerbey337]

I wish I could send my MF 245 and let you fix all the things that's wrong with it you are very good at what you do 🇺🇸

[@thomasschmitthomesteadproj6025]

......Looking good can't wait to see it all working. .....Once again thank you for sharing. ..

[@mtrunk8570]

Great job friend can't wait to see it all working not sure I have seen a rear loader, and you are right on the debt part it's always better to do without than be up to your eyeballs. T.U.

[@dalepeter8392]

Great vid! My T30 3 point is up and down, but front load not doing anything. The hydraulic take off hose to remote control valves is beside fluid level stick. How do I know the pressure it at the control valves?

[@cheaphomesteading]

One thing I forgot to mention on the video I think you need to have something on the 3 point hitch or lock up straps. If you lift the hitch. The pressure will build. can’t just lift it up all the way because the draft will shut off the pressure at the very top. Hope you get it up and running.

[@ten4man116]

I have a Massey Ferguson 165 with a MF32 front end loader. I have owned it for about 6 months now. Everything seems to work on it at this time, however, I would like to work on the carb, and throttle, but the loader is kinda in the way for easy access. Could you tell me how, or let me know of a place on web to go to for information. The pump on the front is tripping me up. I don't want to damage it trying to remove it, and it bolts to the rear axle. Thank you.

[@curtclyne1467]

MF 150. I want to add dual remote hydraulics. Should I use the "Dual remote" hydraulic kit that is commercially available or use the system you used in the video? If your system is better please list product part names etc.. Thanks you make great video! MFguy1

[@TelcoPEI]

That moment when you drill through the fender and you hear "Pshhhhhhhhhhhhhhhhhhhhhhhhhhh"!

[@vishvajitsinhparmar7338]

I want ur help to install the valve in my Massey Ferguson 1035

[@dominpakam8178]

Please show us clearly to where u cannect the all volve pipes.

[@mf8913]

What type of hydraulic fluid do you use?

[@prime553]

How does this work as you don't seem to have a diverter valve?

[@cheaphomesteading]

Uses the pressure from your hitch so the weight of the loader on my hitch will give me enough pressure to run my hydraulic function. If I didn’t need the three point hitch I would just raise it all the way to the top and I would have full pressure to run hydraulics.

[@prime553]

@@cheaphomesteading cheers for the reply, interesting setup % of oil going to lift arm cyclider and another % going to the pipes valve. Works good for you. Yea I know full lift gives full pressure down the pipes. The diverter valve option is the same but means your linkage is dead while you have pipe pressure and adjust ram etc then divert back to linkage.

[@dominpakam8178]

Show us were to connect loader volve pipe.

[@vishvajitsinhparmar7338]

I am from india

[@vishvajitsinhparmar7338]

Hy

[@johnsdsl]

Please save me from the rummaging for bolts.

[@cheaphomesteading]

Thanks for watching man