Installing a Step Down Converter on a Humvee 24/12 volt converter | BULLET HACKS

[@abc-ed1nr]

If you wanted keyed accessories, could/would you pull your 24v hot line from the start switxh?

[@dustye753]

Having the step down converter directly wired will slowly drain the battery correct? If it's a vehicle that sets unused might want to put a switch on the console?

[@tonyfoxxbuilds1920]

Awesome... I'm looking to buy a deuce or 5ton soon and I'd like to change out the lights to 12v leds and add a radio. Also this would help my school bus! Thank you!

[@thannaas]

Nice video! Have you used it with the 4L80E transmission? How do you wire it and how does it work?

[@alekstsymbol8803]

I’m trying to hook up a 12volt camper trailer how would I run 12 volt to the trailer hookup

[@coreym3975]

Something that is puzzling me about this. Don"t you need to run a remote power line in this so there isn't constant power to everything?

[@nx8fds023]

I agree. I was trying to figure out where to connect my 24V USB charger. I ended up tapping into wire 467A on light switch connector. It's the wire that supplies horn and turn signal switch.

[@dagovillarreal7144]

Great video. What gauge of wire did you use for the harness?

[@jeffford4431]

Where does the ground from the fuse box go?

[@cessna421cpilot3]

Do you have to run a ground from the bottom of the fuse block back to the main ground?

[@BulletmotorsportsInc]

Cessna400 Pilot yes, or to the chassis.

[@jeffford4431]

But running the ground to the frame would be a 24v ground correct?

[@Ilendinpa]

@@jeffford4431 Ground has no volts

[@grave_warden_2290]

So it's a 24-12 what happens if only like 20 volts go into it, do only like 10 volts come out

[@couchsurfer2856]

How about some affiliate links to get the converter

[@bynesetcustoms]

does it make any noticable noize? the victron unit that is... :)

[@randyhardee4773]

No fuse protection for the converter?

[@BulletmotorsportsInc]

Fuse is built into converter on side

[@jacobkauffman7742]

So why add that converter when you can run a wire off the 12v portion of the battery as they are wired in a series-parrallel setup. That little tag by your multimeter shows the 12v side and the 24v side? Those are 12v batteries.

[@BulletmotorsportsInc]

Because doing that does not allow even distribution of the 12 volts. By using a converter you are evenly pulling from both 12 volt batteries, allowing the alternator to charge both evenly., not allowing one to draw more ensuring even longevity.

[@ronbonick4265]

man what a life ! work being fun....... Im a slave.. but Thanks for the info it was needed

[@PLxFTW]

I need to do this to my JDM Land Cruiser. Problem is the previous owner did some magic to extract 12v for the head unit and the wiring is a fucking mess

[@motoh9601]

great video