Installing Active Imaging 3 N 1 on Trolling Motor

This applies to the Minnkota Riptide, Minn kota Terrova, and any other free spinning spot lock trolling motor.

[@capt.lennymiller6524]

Great video Paul but I've been to 2 Harbor Freight stores and all they have is 1/4" coil air hose so I'm guessing that this must be what you used not 3/8".

[@PaulGettysFishing]

1/4 inside diameter 3/8 outside

[@capt.lennymiller6524]

@@PaulGettysFishing Okay Paul, working on this for my Ulterra but I'm wondering how you split the air hose without losing a finger, this stuff is tough!

[@PaulGettysFishing]

@@capt.lennymiller6524 I clamped it to a table laying flat and then used a hooked razor knife that roofer use to split it

[@glenncollins9994]

How do you get the transducer cable inside the 3/8 ID hose? It is 3/8 right? Do you have to remove the connector which connects to fish finder?

[@hawkleather9631]

Paul, Do they make a Y cable that splits one 3 in 1 active imageing transducer to 2 individual Ti2 units?

[@PaulGettysFishing]

no sir they do not

[@hawkleather9631]

@@PaulGettysFishing ok, I have decided to purchase the elite fs9 so that I can have live target. But does that mean the unit cannot be switched to down image or side imaging without manually changing out the transducers? And also, will running 2 AI-3 in 1 transducers cause interference with each other? Thank you.

[@PaulGettysFishing]

No u can switch by choosing that on the screen, just press stop sonar on the more options screen when not in use and that will stop the interference

[@69Bowhunter]

Do I have to tie this to my 3-D module for the side scan and down scan to work or can I just hook it straight to my HDS live 9 ?

[@halfaistos]

How did you fish the transducer cable through the 3/8" air hose?

[@codyebnerfishing9783]

Question how do I get my active imaging to work ? Also how do I get my hot maps platinum to work on my elite ti 2

[@PaulGettysFishing]

Once u plug the transducer in it should auto detect it then u should have sonar, downscan and sidescan. Just put navionics card in and it will ask u if u want to switch to navionics

[@kckman52]

where do i get the transducer mount to fit the troll motor?

[@PaulGettysFishing]

precisionsonar.com or russellmarineproducts.com