Installing Dual Wheel Swing-Back Trailer Jack

Installing the 1500 Lb. Dual Wheel Swing-Back Bolt-On Trailer Jack from Harbor fright: went on ok, I found it to be a little on the cheap side as for as tolerances go but should be fine. $3197
parts used: 500 Lb. Dual Wheel Swing-Back Bolt-On Trailer Jack
harborfreight.com
Film Gear Used:
IPad Air: amzn.to/2Exopb...
Soft-box Lights: amzn.to/2Ezg6M...
AMIR Phone Camera Lens: amzn.to/2EwpT5...
GoPro HERO3+ amzn.to/3eOl8Xx
Editing Equipment and software:
PowerDirector 17 Ultra: amzn.to/3d7ZhcK​
Dell Latitude E6420 Laptop: amzn.to/2SHZc3...
MacBook: amzn.to/2yjlLm...
Zelotes Mouse: amzn.to/2LKwJJ...
Stay connected:
Instagram - / channel.ron. .
DISCLAIMER: This video contains Amazon affiliate links, which means that if you click on one of the product links below in the Description or in the video “Channel Ron” we’ll receive a small commission.

[@cameronschneider4314]

I’ve got the same jack but it’s a 2000 pound and I noticed there’s a little bit of play when you want to move the handle up and down is that normal or is it supposed to be a little sloppy.

[@channelron3593]

Yes remember these are from harbor-fright so the tolerances on not going to be tight.

[@cameronschneider4314]

@@channelron3593 I ended up tightening them up a little bit. I think basically any trailer jack is going to be like this but I think the people who put this on my trailer didn’t tighten old enough so I just had to tighten them up a little bit.

[@kingduramax9903]

You installed the bracket on backwards

[@channelron3593]

I did? will have to take a look at it? If so I will fix it, been working fine, Thanks for the infor.

[@timsInSSI]

👍