Installing EuroSpec OEM DRL Fog Lamp + ALL LED SETUP on Volkswagen Vento 2021 | TEST RESULTS

[@xuxuonex]

While you were at it, should’ve changed the front indicators to amber LED’s as well. I have changed the rear brake lights, indicators and single reverse light to all LED set up. Looks like a high end euro car now from behind.

[@dheerajsingh9449]

That is on my bucket list brother Will change to LED'S very soon 🙌

[@rupchrs]

Bro, Can you share video for the same? @xuxuonex

[@dheerajsingh9449]

@@rupchrs I'll upload video for sure! 🙏😊

[@noboom6808]

Doesn't it put a heavy load on the car's battery??? It will be very difficult if the battery fails while on a long drive..

[@dheerajsingh9449]

@@noboom6808 leds consumes less power than halogen bulbs so it won't be a problem .... for example stock bulbs consumed 55w now led bulbs consumes 25w almost half the power.

[@Nannu4444]

Excellent demonstration brother! Can you please show the response of LEDs while you switch on the car from accessory mode to ignition? Do they flicker or not? Thanks

[@gkautomotive]

Can you explain how did you fit the smaller ambient light in the glass holder area? I am not able to fit it correctly in mine.

[@dheerajsingh9449]

@gkautomotive there are two screws under the AC panel and it has enough space u can pass the ambient light through that space (No need to unbolt screws) and then use a double sided tape to paste it under the ac panel It's a perfect fit not visible at all.

[@navmeet7]

Fabulous job. Part No of the Skoda Laura H8 connector installed behind the DRL bulb ? Waiting for the courtesy lamps installation in the door cards & the puddle lamps.

[@dheerajsingh9449]

Thanks bro 🙌🙏 The part number is 1Z0 941 669 I am also waiting for the Lamps as they are in transit, will upload as soon as they arrive 💯

[@navmeet7]

@@dheerajsingh9449 Looking forward to it. I drive a Vento Highline 1L TSI MT. All halogen bulbs including the parking lamps in headlight & tailights changed to LED. Only upgrades left are the DRLs, puddle lamps in the mirrors & courtesy lamps.

[@dheerajsingh9449]

​@@navmeet7great bro 1L Tsi MT vento is the fastest 1Ltsi from the factory and there is one more light upgrade left that I am going to upload soon and it is going to be a surprise.

[@navmeet7]

@@dheerajsingh9449 Yes but I have made that stock fast faster through a remap recently.

[@vishwajeetchavan4191]

Brother what do you think about aozoom LEDs ? I have AMEO which has a similar setup like your car ,Let me know your thoughts about it

[@dheerajsingh9449]

Bro aozoom is a very good brand And it offers some really high power Leds but I would suggest inside a reflector housing u should not use very high power leds because the beam pattern would not be the best + Aozoom Leds are very costly compared to Osram though both are German brands, car originally comes with osram bulbs 55w each and now I am running 25w osram leds so the load on the wires is less too and if u want to install leds more than 55w then relay wiring is a must as stock wiring is not sufficient for high power consumption and it can lead to burning/heating of wires in the worst case.

[@dheerajsingh9449]

High power leds in reflector housing is not the best with the beam pattern so it also disturbs the oncoming traffic.

[@sangeetbabber9344]

Great Dheeraj 😊

[@dheerajsingh9449]

Thanks 😊😊

[@rahulkhanna2924]

bro do you have any idea which bulb is used in the rear fog lights of vento and if possible plz provide the part number as well coz I didnt have one when i purchased mine but now im getting difficult to find the right one. Plz help if possible....thanks

[@dheerajsingh9449]

bro Rear fog light uses the same bulb as indicators which is P21W 180degree

[@laxmiraj7537]

Eagerly Waiting for the door warning light video❤😊

[@dheerajsingh9449]

Yeah going to upload soon 🙌

[@trushaltandel3017]

Bro which dash cam u are using I also need one for i 20 front and rear both

[@dheerajsingh9449]

@@trushaltandel3017 70mai A200 HDR Dual Dash Camera,... www.amazon.in/dp/B07Q85SLCS?ref=ppx_pop_mob_ap_share

[@khalidmanzoor6842]

What is the capacity in Ah of the replaced amaron battery? The stock Exide battery is 35 Ah

[@dheerajsingh9449]

@@khalidmanzoor6842 45Ah

[@khalidmanzoor6842]

@dheerajsingh9449 how did you upgrade from 35 to 45 Ah? Won't it damage the electrical components?

[@dheerajsingh9449]

@khalidmanzoor6842 Ah is mainly an estimate of how long can a battery last with 45Ah battery, you could use the stereo with the engine turned off for 1Hr before the battery charge reached the minimum threshold. In the case of 35Ah, you can use the stereo for 45 mins by the time the battery reaches the minimum charge threshold.

[@dheerajsingh9449]

@khalidmanzoor6842 if the alternator is rated at 120Ah, from the moment the car is started, all the power needs in the car is provided by the alternator including charging the battery. Now if the sum of the electrical load exceeds 120Ah then the excess demand is provided by the battery. In such a case, the battery is in drain-in-progress condition

[@dheerajsingh9449]

@khalidmanzoor6842 As long as battery is 12V it won't hurt the car . The car draws what it needs to ✨️

[@gkautomotive]

Great video bud! Informative? Possible for you to share the links for LED bulbs ?

[@dheerajsingh9449]

Thanks 😊 Here is the link Automaze 1156 BA15S 180 Degree... www.amazon.in/dp/B09MTSHQHP?ref=ppx_pop_mob_ap_share

[@supernikhil2]

@dheerajsing9449 Can we do the same LED setup at least for the headlight in the 2014 Vento model. Also, what is the cost of all LED

[@dheerajsingh9449]

@supernikhil2 yes you can but 2014 vento uses H4 LED Single bulb is used for low and high beam, the one I am using costs 3500rs/ Pair H7 [ OSRAM] Pricing for H4 can be different.

[@pranjalchanne7038]

Very clean work broo ❤❤

[@dheerajsingh9449]

Thanks bro 🙏🙌

[@btdsaikumar8653]

Can we upgrade the led lights to osram 50 w led or 25w is the maximum we can try for vento / polo

[@dheerajsingh9449]

U can install any watt led But 50w inside the reflector housing would be the best !

[@FarooqPSK]

Bro, I loved the way you spent so much time and effort on this, i Have some questions as well as a suggestion too. 1. You couldve gone for 4300K LED lights for visibility in rain and fog, 6000k are a pain and hazard. 2. Can you please detail about the wiring little more including the wire used? I want to do the same thing on my vento. 3. Little more on how you sourced the laura P21W connectors, part numbers will help more too. 4. 15A fuse slot and the way you connected the wiring to the new connector. 5. I want to use federal lights (blue and red one) with a remote that comes and goes off with ignition. Can you guide on that too?

[@dheerajsingh9449]

thanks bro 🙏 1. Bro to be honest when we say 4300k is good for visibility in rain that is true but the difference is not drastic I have used both Kelvin bulbs and I have realised if the light(6000k) is very bright then there is no problem in rainy season, visibility is good I don't find any problem while driving. 2. I have used 1mm - 1.5mm copper which you would find easily at an electrical shop. 3. One of my friends owns a garage so he had a scrap Skoda Laura ( part number- 1Z0 941 669 it is not necessary to use the P21W connector from laura, you can use any P21W connector just it should be round in shape and then just be creative with it.(YOU JUST NEED A CONNECTOR FOR LED) Remember you are going to use that part of fog light as DRL so you cannot use a normal h7/h8 led in that housing ( I mean if you want then you can but then it is going to be veeerryyy bright therefore it would disturb oncoming traffic in even daylight whereas P21W LED is not very bright that is why it is the right choice. 4. just connect in the series connection ( +ve signal from connector wire > FUSE > FOG LIGHT > GROUND(-ve). 5. For that you need a 12v Socket Female connector ( u can get that on Amazon) Then if u own vento/polo U can tap into fuse number 16. Connect the + ve wire of female Socket to fuse number 16 and -ve to Chassis( ground).

[@FarooqPSK]

@@dheerajsingh9449 Take a bow for your patience in helping fellow vw owner. Thanks alot. I took a screenshot of this response. Its little difficult to get hold of a holder right now as I want to make it feel like OEM but will keep trying till I get one. Also regarding 4300Ks, I got 55Wx2 for Low 55Wx2 for High beam and 55wx2 for Fogs on my vento. Its like day driving without bothering anyone on road especially oncoming traffic.

[@FarooqPSK]

​@@dheerajsingh9449by the way when you meant by Fuse 16, is it fusebox thats near the battery? If its the internal one, how do you run the wire into the cabin?

[@dheerajsingh9449]

@@FarooqPSK fuse box under your steering It has numbering (fuse no. 16) Is acc meaning it has power when ignition is turned on.

[@dheerajsingh9449]

@FarooqPSK from fuse box you can route the wire behind the stereo and you can place your 12v charger behind your stereo and use one of the stereo bolt for ground . Left and right panel (when u open the door near the hinges)of your dashboard can be removed, from there you can run your light wires.

[@devishidutta7043]

Very informative buddy. Keep going on👍🏻🧿

[@dheerajsingh9449]

Thanks 😊

[@sudeepg883]

Hey Dheeraj - do you know anyone who can help do the setup on my car as well?

[@dheerajsingh9449]

@sudeepg883 u can try contacting theretrofit_panda on Instagram he might be able to help you

[@vishwajeetchavan4191]

what is the blub size of parking bulb ?

[@dheerajsingh9449]

T10 / W5W

[@Kevindz113_]

bro where did you get the steering wheel trim from? any source?

[@dheerajsingh9449]

@Kevindz113_ I didn't get you bro ?

[@Kevindz113_]

@@dheerajsingh9449 you added the gloss black plastic piece on your steering wheel. Where did you get it from?

[@dheerajsingh9449]

@Kevindz113_ bro that comes OEM with Vento In polo it is Matt finish

[@nitinjangir765]

Well done bro!!

[@dheerajsingh9449]

Thanks bro 🙌 🙏

[@vishwajeetchavan4191]

Thanks alot this video saved my time

[@dheerajsingh9449]

🙏🙌

[@kavalarajaekhar6890]

Is it possible on my polo 1.5 tdi 2015

[@harshitsingh6941]

Well done bro 👍

[@dheerajsingh9449]

Thanks bro 😊

[@amansingh-r3w9m]

NYC vedio man 🎉

[@dheerajsingh9449]

thanks 🙌

[@Nani0678]

Well done nice DIY

[@dheerajsingh9449]

Thanks bro 🙌🙏

[@youtubesynex7679]

Bro how much did it total costed you?

[@dheerajsingh9449]

Bro around 14k-15k

[@suryasuri5876]

Cost how much

[@dheerajsingh9449]

@@suryasuri5876 14k-15k

[@vickysharma6055]

How to fit other horn?

[@dheerajsingh9449]

For that u would need a metal plate adapter so the horn can fit on to that and after that just connect the unused factory connector directly to the horn

[@guyshesaidnottoworryabout3774]

u sure...DRL is connected to stock wiring.....as DRL should dim when lights are turned on.....doesnt seems to be the case here or is it.....btw that Polarity of LEDs explaination was straight out lifted from a red car guy...hehe

[@dheerajsingh9449]

These DRLs are fitted with additional wiring only 12v signal is taken from stock wiring so they glow with full power Diming effect should come if drl wire is connected to a canvas/module as it is in interior lights So if these headlights had stock drls like in rapid rider variant tapping into that wire will definitely dim the additional drls and yeah I luv watching red car guy videos they are really informative 👌 😊

[@tirthbrahmkshtriya2498]

great video

[@dheerajsingh9449]

Thanks 🙏🙌

[@devishidutta7043]

Oh god so niceeeee👍🏻👍🏻❤️

[@pranjalchanne7038]

Please make a video while driving on a highway

[@dheerajsingh9449]

Sure bro I'll upload a short 🙌

[@ramansingh8050]

Great bro👍

[@dheerajsingh9449]

Thanks ✌️