Installing front LED turn signals on a 2007 Victory Vegas

After installing LED signals on the rear of my bike, I found they went into hyper-flash when the bike was running (14 volts), and worked normally when not running (12 volts). I figured there must be a problem running incandescent signals in combination with LEDs. Therefore, I decided to switch out the front ones for LEDs. This turned into a bit of a dumpster fire, but I eventually figured out what was going on.

[@omidmark07]

Thank you sir for making this video.

[@grinchbiker5399]

My pleasure!

[@1973cfh]

Couldn't you just use a metric bike diode kit to solve the hyper flash issue. I only ask because that is my plan but not sure if it will work.

[@grinchbiker5399]

Good question, but I don't know the answer. If you try it, please let me know. I'm always looking for better solutions.

[@Papi400]

Question. Is the reverse wiring on the right side for all year vegas or just the 07?

[@grinchbiker5399]

Don't quote me on this, but I am under the impression that it was an issue up to 2007, and changed in 2008. I would verify on your bike before doing anything. The 2007 wiring diagram I have shows the reverse polarity wiring, if you get a hold of the diagram for other years, hopefully it will show which way it is.

[@Papi400]

@@grinchbiker5399 Ok thanks. Greatly appreciated