Thanks for the upload and the time to make this and rapid to the comments.
@romanoverlengia54216 ай бұрын
Use a Brass Punch and hammer when working near fuel tanks.
@jamespierce27852 ай бұрын
ur killing me smalls lol
@TbuckeT81Ай бұрын
I swear I saw something spark under that tape right where that why is.
@mjhucks2 жыл бұрын
I pulled my bed, but I’ve done it both ways and there’s no easy way
@jamespierce27852 ай бұрын
hey bro you have a short in those wires somewhere if you keep starting it then moving the wire to kill it you are wrecking your coil fix the sh😮😮rt
@michaeldeeveers4246 Жыл бұрын
Mine did not come right off
@v7nf7 ай бұрын
Try this after lock rings are completely fkin rusted rusted !!!so you either spend 400-700 bucks for a tank not made anymore with all its lockring tabs or you go to junkyard geta good tank with a big 1.5 inch hole in it the junkyard drilled in it and plastic weld peaces of your old tank to it for under a 100 bucks....fkin easy man and before someone out there says, all I did in that situation was drilled screw bolts into it and bolted it ,bullshit that dont work.!!!oh yea the ol did you take bed off or drop tank debate ,well yea I did both 4 times
@joshsykes6877 Жыл бұрын
Do you know when the fuel pump relay is located on that exact truck?
@BASgarage Жыл бұрын
I’m honestly not sure. I sold this truck a while back to a friend I’ll reach out see but I believe it has a book with the locations in it.
@franksaccente Жыл бұрын
In the fuse box under the hood should have the diagram on the cover
@blacknightgaming8987 Жыл бұрын
fuel pump relay is actually a solid state chip on a circuit board underneath the fuse panel
@LightGesture Жыл бұрын
Coil packs, weak spark?
@liamgilfillan3859 ай бұрын
How did you access unplug everything? From the wheel well?
@BASgarage9 ай бұрын
Yes, I lowered the thank down with a floor jack just enough to get to the connections on the top.
@jamespierce27852 ай бұрын
you don't need a new coil
@jamespierce27852 ай бұрын
I'm telling ya u broke other side somewhere that ight by your hand two wires have rubbed thru you need to tape wires better
@scottdunn24672 жыл бұрын
did you ever find issue?
@BASgarage2 жыл бұрын
Yes ended up being the main wiring harness had fallen down on the exhaust and melted/burnt some wires.
@tylerangel4073 Жыл бұрын
Ain’t that a bitch
@LightGesture Жыл бұрын
@@BASgarageouch
@francoisbrand61116 ай бұрын
did u figure it out?
@BASgarage6 ай бұрын
Yea wires had gotten against the header and melted together
@deshawnharris8948 Жыл бұрын
What was the actual problem
@BASgarage Жыл бұрын
Melted wires on the exhaust manifold from previous owner. They had replaced the engine and didn’t get the main wiring harness secured melted a couple wires. (Was a pain but finally found it)