Installing the Taco Moto Co Ultra Thin CNC Fuel Tank Tap

Installing the TMC ultra thin tank tap.
tacomoto.co/pr...
tacomoto.co/pr...

[@jeffknobby2700]

Need some restocking on the website 💯

[@johnoverbagh6036]

Say-wheat! This and the tubing is going to be great on my IMS tank upgrade to my GET race kit on my 19’ TPI 300. Was having some routing issues on the stock tank, will solve either problem. Thanks dude.

[@mt1885]

The best fuel tap! Also I use silicone grease as well.

[@SalSpaceKhan]

Goddamnit I don't need it, but I want it.

[@netterjeff4013]

Ditch the single use clamps! I always replace them with tabbed hose clamps. No tools required and they are reusable!

[@rtwpaul]

Genius level

[@madman432000]

I have an Acerbis 3 gallon tank and the stock tank setup with pumps but still using the original straight fittings. Have not had any issues until yesterday with the 3 gallon Acerbis, 2 miles from the truck I look down to see a stream of fuel spraying about 18" to the side. Back to the truck and removed the fuel hose and had to cut it off and it worked fine. But if I want to replace fittings on both tanks to this style would I have to buy 2 kits or can I get one kit and just an extra barrel? I suspect I have a thick and a thin wall tanks. I could use one nut on the stock tank and the other nut on the Acerbis tank. Otherwise I may just get the bendy hose and continue on with the stock setup. 2016 500exc

[@ADVNevada]

Great information 👍

[@co4x4]

Why is this mod necessary or preferred over stock? Serious question Im new to these bikes. Cheers from Denver Colorado

[@TACOMOTOCO]

Oem is tall and plastic

[@MackB2023]

Do you sell the silicone grease?

[@wildwoodovensbbqs]

N)