Integrating TCS LCC system with the NCE system

[@TCSDCC]

Important Note for this video: The NCE Throttle and Command Station/Booster can preform Macros that are programmed on the CS-105 Command Station.

[@BriansModelTrains]

Will this work with the NCE PowerCab or does it only work with the ProCab system? Thanks!

[@TCSDCC]

Brian, Since the ProCab is it's own Command Station and it has no booster, it will not work. The Booster on the Command Station will talk to the BA-100 Booster Adapter and then the CS-105 Command Staiton. If the ProCab and CS-105 were hooked up, they might get confused of who is commanding the trains and also the magic smoke might get releases from one or the other. -Carson

[@BriansModelTrains]

@@TCSDCCThat makes sense, thank you for the reply.

[@davidhill3724]

you need to show how you can use your phone with apps like engine driver

[@TCSDCC]

Well for the NCE System, you would connect your phone to the WifiTrax module through it's WiThrottle server that it is advertising.

[@brock50pullingvideos]

I watched another video where the NCE procab was just plugged into the front of the CS-105 with the curly cord. You don't need to go through the throttle bus according to one of your other videos. You guys are confusing the heck out of some of us. You think everybody is running big layouts and need every little gadget. How about some basic stuff???

[@TCSDCC]

The NCE Procab will not work if plugged into the front of the CS-105. Those are LCC ports for the LCC network. The Throttle Bus in the rear of the CS-105 is solely for NCE throttle bus for the NCE throttle bus network. If you do plug it in the front of the CS-105, it will not work and also it cause damage to your NCE and or CS-105.