Inteligent Pulse Repair Charge Car , Motorcycle battery , 12V , disassembled, tested and measured,4K

[@andryrasoanaivo9640]

Is it normal that just after you plugged the charger into the power outlet, and tested the DC current from it when it is not connected to any battery, there is almost 0 volt instead of the 13,8 volts displayed on the device ? Maybe is there any protection mechanism ?

[@AutoMotohowto46]

it has some protection, when it doesn't sense the load above 7V, it doesn't start as far as I remember .

[@andryrasoanaivo9640]

@@AutoMotohowto46 Thanks. I was about to buy one like it today but I hesitated when I noticed this, fearing that there is any malfunction or manufacturing defect.

[@AutoMotohowto46]

@@andryrasoanaivo9640

[@teodorap.2728]

I have the same one,and after charging its shown FUL,but voltage on charger is stil 15v and fan stil works.Does it still charge,even it shows FUL on display?

[@AutoMotohowto46]

Select , car battery or AGM or motorcycle , and yes on full you can leve to charge mor 2 hours and no problem charger will go on

[@teodorap.2728]

@@AutoMotohowto46 Thanks a lot!I've also disassambled mine and put Arctic MX-4 thermal paste between those two heat sinks and mosfets to provide extra cooling.

[@AutoMotohowto46]

@@teodorap.2728 i must do to ❤️❤️❤️❤️

[@AhmedAdepoju-v9h]

Welldone....i have a very similar charger but the fuse got blown but couldnt determine its rating. Could you please state what the rating of the fuse is? Thanks

[@AutoMotohowto46]

But it should be written on it, you can't see anything written on it?

[@AhmedAdepoju-v9h]

@@AutoMotohowto46 nothing is written on it.

[@AutoMotohowto46]

@@AhmedAdepoju-v9h in this case, install a 2A one if it burns out and go up to a maximum of 5A, I think 8A is already too much .

[@AhmedAdepoju-v9h]

@@AutoMotohowto46 thank you

[@AutoMotohowto46]

@@AhmedAdepoju-v9h welcome

[@samstone446]

Your multitester seems defective. Before you even close a circuit the values jump all over the place?

[@AutoMotohowto46]

possible, I don't know what to say, I do my job with him

[@nevereverlistens]

some digital multimeters do that. This is why electricians still use dial multi-meters

[@rwd1973]

I like this charger. It doesn't give 6A, more like 5.2A but that is ok. Most cheap chargers just charge until they reach 14.4V and then starts the trickle charge but this one actually locks the voltage at 14.4V and lowers the current until the battery is full

[@AutoMotohowto46]

Agree ❤️❤️

[@Qkfltpdls777]

How do you select repair mode although there’s no mode on the device?

[@AutoMotohowto46]

I don't remember exactly, but an icon appears on the screen when you are in pulse mode

[@blackdogchris]

Thanks mister

[@AutoMotohowto46]

welcome sir'

[@YomAlwa3eed]

So is it a good charger or not?

[@AutoMotohowto46]

Good

[@NathanieiHugh]

550 Schoen Walk

[@AutoMotohowto46]

?

[@ЕвгенийЕвгений-т3к]

Looks like the tester is on a very low budget, that's the problem

[@AutoMotohowto46]

Problem ?