Introducing the Ultra Race B & K-Series Billet Ultra Race Manifold!

Check it Out Here:
skunk2.com/bil...
Call to Preorder:
951-808-9888
The Skunk2 Ultra-Race Series Billet Intake Manifold for Honda B Series and K20/K24 Engines is the ultimate manifold for high horsepower street and race engines. Though the standard Ultra Manifold already allows for 8 injectors to be mounted using two fuel rails, we listened to racer demands and built the Skunk2 Ultra Manifold, which features a top-side, 8-Injector, single-rail setup. All Ultra Manifolds feature tapered runners with trumpet-profiled entries and plenums that were designed and optimized using CFD and the dyno. The short-tapered, high-volume runners combined with oversized plenum runners favor maximum top-end power over lower-end power and response. The best part about this project was that the hard part was completed years ago, when we spent countless hours on the dyno developing the original cast Skunk2 Ultra Manifolds. There was no reason to mess with a great and proven design.
The manifold features the same Skunk2 Ultra high-flowing runners and modular plenum design, which allows plenum volume to easily be increased using simple spacers, and the runners can be freely ported for additional flow and volume. Other than being made from billet, the only revisions we made were the injector mounting area. The versatility of this manifold allows enthusiasts and engine builders to tune the manifold combination to best suit their needs. Indeed, the billet coolness factor combined with the fact this proven Ultra manifold design is only produced in limited quantities which makes this a special offering. Act now while supplies last.

[@t.j2881]

You guys really need to release an Ultra manifold for H series...

[@balancemode4112]

I just purchased the Skunk2 Racing Radiator for my Subaru BRZ for K24 swap✌🏻 I’ve purchased Skunk2 radiator for my 2006 Civic SI, held up very well i’m here again buying

[@SIRICKO]

I hope they fit b18b engines!!! this time!

[@theedge5584]

Right. Or one can fab an adapter to match up...bolt patterns a lil different between LS and vtecs

[@tunanocrustgarage]

Its says B & K, good to go.

[@tunanocrustgarage]

SO much want!

[@djbing845]

Will these work for turbo b series?

[@grimreaper5401]

You guys are fuckn crazy 🤣🤣🤣

[@101glassdan]

What's the part number for this intake???

[@Skunk2Racing]

skunk2.com/k-and-b-series-billet-racing K-Series Side Feed: X307-05-0350 K-Series Center Feed: X307-05-0400 B - Series Side Feed: X307-05-0100 B-Series Center Feed: X307-05-0200

[@TeamVengeanceIE]

Can’t wait to purchase the BLOX version of this 😂